FLX Babymaker Owner's Manual page 8

The Babymaker | Owners Manual
ASSEMBLY
Overview
The following section covers the assembly directions for the Babymaker. This
process is very similar for both Standard and PRO models. Proper assembly is an
essential step in ensuring your safety and the proper operation of the bike. If at any
point you do not feel comfortable assembling the bicycle yourself, please seek
professional assistance or reach out to our support team.
You can also find a detailed assembly video on the FLX YouTube channel:.
www.flx.bike/babymakerassembly
If you do not feel that you have the ability or skill to assemble the bike
yourself, please take it into a local bike shop for professional assistance.
Failure to properly assemble your eBike can result in serious injury or
death.
Please read through the entire assembly instructions section before you
begin. Proper assembly is important in order to ensure your safety and
satisfaction while operating your eBike.
Tools Included:
2.5 mm, 4mm & 5mm Allen Keys
12
T25 Torx Bit 15mm Wrench
www.flx.bike
STEP 1: Install the Handlebars
1. Using the 4mm Allen wrench, unscrew the 4 bolts and remove the stem plate.
2. Place your handlebars into the groove and replace the stem plate over the top.
Tighten the bolts about 3/4ths of the way.
3. Make the final adjustments on your handlebars positioning ensuring that they are
centered and at a comfortable angle before tightening the b olts the rest of the way.
Note: DO NOT depress the brake levers before installing the front wheel.
Figure 1. Stem Plate Bolt Removal
STEP 2: Connect LCD Display
Figure 3. Connecting the LCD cables
The Babymaker | Owners Manual
Figure 2. Tightening Stem Plate Bolts
1. Once you've secured your handlebars,
locate the cable running from the back of
the LCD display and connect it to the
corresponding cable located near the
charging port of your bike.
Tip: Line up the two arrows to
ensure proper connection.
www.flx.bike
13