Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
Align the bulkhead nut hole on the other end of the upper armrest assembly with the ear plate hole on
the back of the meter head, and use M8x16 screws (same column mounting screws) to screw into the
bulkhead nut hole through the ear plate hole, and then screw in 2-3 turns.
After confirming that all the screws in steps 1 and 2 above have been screwed in, start tightening one
by one from the meter head.
Install the support cover on the back of the meter head and fasten it with screws (M5x14).
50
Advertisement
Table of Contents
