Ezzy Power Slalom Tuning Manual

1998 Ezzy
Power Slalom
Rigging &
Fine Tuning Guide
1) Slide the mast through the luff sleeve. Note: slide the mast
above the cams (do not attach the cams to the mast yet).
2)
Attach the mast extension and thread the line through the
cleat. Do not tension the downhaul yet, just cleat the line off.
3)
Attach the boom and outhaul to the boom length that is
printed on the sail..
Quick Tip: The suggested boom length is measured from the center
of the boom cutout.
4) Attach the cams to the mast by pushing down on the batten
with the palm of your hand, approximately 12" (30cm) from
the luff sleeve, and snap the cam onto the mast with your
other hand.
Quick Tip: If the cam is difficult to put on to the mast, check that
the batten tension webbing is loosened until the Velco touches the
buckle. This will allow the cam to slide further from the mast and
will make it easier to get the cam on to the mast. Also, make sure
the sail is outhauled flat before attempting to snap cams on to the
mast.
Quick Tip: Opening the zipper will make it easier to snap the cam on to the mast. But, to avoid damaging
Rigging a 1998 Ezzy Power Slalom Sail
RIGGING:
Page 1