Pre-Operation; Technical Specifications - Husky 935 263 Use And Care Manual

Pre-Operation

TECHNICAL SPECIFICATIONS

Power Supply
Measuring Range
Optimum Operating Temperature
Accuracy of Vials
Accuracy of Digital Display
Laser Diode Type
Laser Class Output
Accuracy of Laser Line
Estimated Battery Life for Laser
DIGITAL LEVEL FEATURES
This digital level is a manual-leveling tool that can be used inside and outside for horizontal (level), vertical (plumb),
and square alignment projects. It comes fully assembled. Please read and understand all instructions in this instruction
manual before using the product. Figure 2 and the list that follows describe the features of this level.
10
5 4 7
8 6
1. On/Off – Press this button to turn the level on. Turn the level off by pressing and holding the button for about two
seconds. The level will automatically shut off if left idle for fi ve minutes.
2. Reset – Absolute/Relative Angle Conversion button.
3. Beeper Button
last saved angle in the memory.
4. Memory Button – Saves the angle displayed on the screen. Nine consecutive records can be kept in memory.
Press the button again to return to the measurement mode.
5. ° %/In/Ft Button – Press to change the display units from degrees (°), to pitch (in/ft), to slope (%). Pitch readings
are in 1/8 in./ft increments. Plus and minus signs indicate that the pitch is slightly more (+) or slightly less (-)
than the pitch shown on the display.
2 "AAA" 1.5-Volt Batteries (not included)
0-360°
32° F to 104° F (0° C to 40° C)
±0.029° (level or plumb) - See Figure 1
±0.1° (level or plumb), ±0.2° (all angles)
Red Laser Diode 650 mm
Class II Maximum Power < 1 mW
±1/2 in. @ 12 ft.
25 hours with alkaline batteries
2
1
8
3
- To activate and deactivate the beeper. The beeper will sound at level, 45°, plumb, and the
9 13
Figure 2
0.029˚ = 0.5mm/m
Figure 1
14 11 14
12 13 13