Operation - Zenoah BT250 Owner's Manual

OP1
OP2
OP3
OP4
26
English

8. Operation

■ STARTING ENGINE
The cutting head will start rotating upon the engine
starts.
1. Rest the unit on a flat, firm place. Keep the cutting
2. Push the primer pump several times until overflown
3. Move the choke lever to the closed position. (OP2)
(1)
(1) Choke lever
A
(2)
(3) B: the open position
4. Set the ignition switch to the "start" position. (OP3)
(1) Ignition switch (2) Stop
(3) Start
B
(3)
5. While holding the unit firmly, pull out the starter rope
• Avoid pulling the rope to its end or returning it by
6. Move the choke lever to the open position (OP2).
7. Allow the engine to warm up for several minutes
1. When restarting the engine immediately after
2. Overchoking can make the engine hard to start due
WARNING
head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.
fuel flows out in the return tube. (OP1)
(2) A: the closed position
quickly until engine fires. (OP4)
IMPORTANT
releasing the knob. Such actions can cause starter
failures.
And pull out the starter rope quickly to restart
engine. (OP4)
before starting operation.
NOTE
stopping it, leave the choke open (OP2) and push
the primer pump several times (OP4).
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.