G&G TS-100 User Manual page 9

Auto power off:
II. Operation
o Place the scale on a horizontal flat surface. Press [ON/OFF] key.
o Wait until the LCD displays "0.00".
o Put the object(s) on the weighing platform.
o Using the [MODE]-key to switch the weighing units.
III. Tare Weighing
o Turn on scale as described above.
o Place the "tare item" on the platform.
o Press the [Z/T] key and wait until "0.00" is displayed.
o Add the "net-weight-item".
IV. Weighing units
o Turn on scale as described above.
o Press the [MODE] repeatedly to change the weight unit until the
required weight unit appears
V. Counting Function
o Press and hold the [C] key till display shows "PCS". Press the
[MODE] key to select a reference amount (25, 50, 75 or 100 pcs)
o Place a certain amount (25, 50, 75 or 100 pcs) of the item which
you want to weigh and count onto the platform. Press the [C] key
to active the counting function. The LCD will display "XX", and the
reference value be confirmed. The counting function is ready!
o With parts counting you can either count parts into a container
or remove parts from a container. As a rule: The higher the
reference quantity the higher the counting exactness
o Now with pressing the [MODE] key to return the weight mode,
and press the [C] key to enter the counting mode.
After about
weight change
60sec. without