G&G TS-100 User Manual page 10

VI. Calibration
NOTE: The scale has been calibrated by the factory. For the calibration, a
preset adjustment weight is required. Without such a adjustment weight
the calibration is not possible and leads to erroneous values.
Please ask the merchant for the suitable test weights.
o Turn on the scale by pressing the [ON/OFF] without a weight on
the scale. Wait until the display shows "0.00".
o Press and hold the [MODE] key for 3 seconds until the display
shows "CAL", then release the button. Depending on the model
the Display will show "CAL" flashing and automatically continue
at the next step, if not press [MODE] again. The Display will now
start to flash.
o After a few seconds the Display flashes "XXX g" on the display
(required adjustment weight).
o Place the requested weight on the surface and wait until the scale
indicates the value. Depending on the model the scale now will
show "PASS" or a new calibration-value. If a new weight is
required remove the old weight and place the new weight on the
surface, wait until it shows "PASS"
o As soon as you see "PASS" the calibration is completed
successfully.
Tel: +49 (0 21 31) 1 33 56 05
Fax: +49 (0 21 31) 1 33 56 07
Email: info@gandg.de
Homepage: www.gandg.de
G&G GmbH
Novesiastr. 31
41564 Kaarst
Germany