Related Manuals for UAS SMOGHOG SHM-05C
Summary of Contents for UAS SMOGHOG SHM-05C
- Page 1 OWNER'S MANUAL SMOGHOG Media Mist Collector ® l Models: sHM-05C & sHM-08C Model SHM-05C Shown...
- Page 2 Should you need assistance, call the United Air Specialists, Inc. customer service number shown below. To expedite your service, have the following information available when contacting UAS. UAS ORDER #: ________________________________________________________________ UNIT MODEL #:________________________________________________________________...
-
Page 3: Table Of Contents
TABLE OF CONTENTS Page Safety PrecautionS SMoGHoG nomenclature 1. iMPortant notice 2. introduction 2.1 SMoGHoG nomenclature 2.2 equipment description 2.3 Principal of operation 3. inStaLLation 3.1 inspection and off Loading 3.2 installation Preparation and Planning 3.3 discharge component installation 3.4 Mechanical installation 3.5 electrical connection 3.5.1 electrical Supply Power 3.5.2 electrical Basic controls... -
Page 4: Safety Precautions
SAFETY PRECAUTIONS We have provided many important safety messages in this manual on your SMoGHoG SHM. always read and obey all safety messages. this is the safety alert symbol. this symbol alerts you to potential hazards that can kill or hurt you and others. all safety messages will follow the safety alert symbol and the word “danGer”... -
Page 5: Smoghog Nomenclature
representative. - Page 6 SMoGHoG reV: 17f ® SHM Series Models 61-10128 FIGURE 1A SHM-05C Basic Equipment Description 61-10128 FIGURE 1B SHM-05C Basic Equipment Description...
- Page 7 SMoGHoG reV: 17f ® SHM Series Models 61-10129 FIGURE 1C SHM-08C Advanced Equipment Description 61-10129 FIGURE 1D SHM-08C Advanced Equipment Description...
-
Page 8: Principal Of Operation
SMoGHoG reV: 17f ® SHM Series Models 2.3 PRINCIPAL OF OPERATION becomes increasingly difficult for either the carrier or the the purpose of the SHM is to collect fugitive mist generated supplier to assume responsibility for any damages after by various industrial processes during operation. the too much time has elapsed. -
Page 9: Installation Preparation And Planning
SMoGHoG reV: 17f ® SHM Series Models 3.2 INSTALLATION PREPARATION AND work. this includes the unit and electrical controls. ensure to leave an appropriate amount of room around your unit PLANNING to allow for maintenance and servicing. a minimum of Prior to the actual installation of the SHM, the location 3 feet (1 m) of clearance is recommended for service in should be readied. -
Page 10: Mechanical Installation
SMoGHoG reV: 17f ® SHM Series Models 3.4 MECHANICAL INSTALLATION CAUTION D A N G E R the SMoGHoG should not be used for support of personnel or material. check with local building code/ CRUSH HAZARD structural engineer to ensure proper installation to roof truss or any other mounting method. - Page 11 SMoGHoG reV: 17f ® SHM Series Models 61-10144 FIGURE 3B Typical Machine Mount...
- Page 12 SMoGHoG reV: 17f ® SHM Series Models 61-10127 FIGURE 3C Wall Mounted Unit Wall mounted units are mounted to the side of the customers machine or a nearby wall. refer to figure 3B above for proper mounting locations and instructions. Various wall mount brackets are offered and should be selected based on the desired orientation of the unit when fully assembled.
-
Page 13: Electrical Connection
SMoGHoG reV: 17f ® SHM Series Models 3.5 ELECTRICAL CONNECTION Descrip�on of Wiring Diagram Appendix Basic Units the SHM is available with various controls configurations. refer to the section headings below and follow the Remote Panel Touch Controls section instructions that best align with your specific unit. Advanced Unit W/ Remote Controls the SHM customer electrical connections are located Transformer 575:480... - Page 14 SMoGHoG reV: 17f ® SHM Series Models 61-10129 FIGURE 4 Remote Panel Touchscreen Connection...
-
Page 15: Advanced Option Unit
SMoGHoG reV: 17f ® SHM Series Models 3.5.3 ADVANCED OPTION UNIT Note: a relay coil cannot be connected to the SHM and will not work for this type of electrical circuit. the main control panel for the advanced SHM unit is a touchscreen interface located remotely in an auxiliary 3.6 FILTER INSTALLATION enclosure (refer to section 3.5.4) that operates the... - Page 16 SMoGHoG reV: 17f ® SHM Series Models 61-10133 FIGURE 5 SHM Filter Removal & Installation...
-
Page 17: Drains
SMoGHoG reV: 17f ® SHM Series Models 3.7 DRAINS airflow or evaluating capture at each collection point. it is recommended to record baseline performance All SHM units are supplied with 1-1⁄2˝ FNPT drain parameters so the system can be reset in case of an connections. -
Page 18: Touchscreen Operation
SMoGHoG reV: 17f ® SHM Series Models 4.3 TOUCHSCREEN OPERATION 4.3.2 STANDARD FORMAT the icon key, table 3, outlines the various icons that are 4.3.1 START-UP AND HOME SCREEN used on the screen for various reasons and may indicate status or conditions. the Home, Settings, and information the display will turn on automatically when the system is icons are shown at the bottom of most screens and will powered up. -
Page 19: Basic Screens
Languages with unique characters will require a different program be loaded into the PLc/touchscreen. this should only be done before the unit is shipped, by a technician during install, or with guidance from a uaS representative. Figure 9 the standard blower screen will display the status 4.3.4 AUTO-FLOW SCREEN... -
Page 20: After-Filter
SMoGHoG reV: 17f ® SHM Series Models 4.3.5 AFTER-FILTER When this option is selected (see figure 21) the Blower Power button in figure 7 will put the unit in standby when touched by the operator. When this setting is selected the indicator to the right side will change from off to on and turn green. - Page 21 SMoGHoG reV: 17f ® SHM Series Models the auto-flow Settings screen can be selected in the Locked Settings group on the customer settings screen. auto-flow is an option that is selected at time of order and loaded into the SHM at the factory. the auto-flow Settings will allow the unit to maintain a precise operating point based on a desired air volume.
-
Page 22: Service
assistance. -
Page 23: Installation Procedure For Coalescing Peach ® Saturated Depth Filter Elements
SMoGHoG reV: 17f ® SHM Series Models 5.2.1 INSTALLATION PROCEDURE FOR 5.3 CONTAMINANT REMOVAL PEACH SATURATED DEPTH FILTER ® Manual draining of the sump itself should not be ELEMENTS necessary unless no drain is used. if this is the case, be sure to drain the sump regularly. -
Page 24: Troubleshooting Guide
6. TROUBLESHOOTING GUIDE use the troubleshooting guide to correct any problems WARNING that occur with your oil mist collection unit. if the problem or condition continues, contact the uaS customer service all electrical/mechanical troubleshooting should be office. performed by a qualified electrician/maintenance individual familiar with uaS equipment. -
Page 25: Replacement Parts
SHM Series Models 7. REPLACEMENT PARTS to order replacement parts, refer to figure 22. order through your local uaS representative or contact united air Specialists at 1-800-252-4647. Please have the unit model number, serial number (from component access door) and part numbers available when ordering. - Page 26 SMoGHoG reV: 17f ® SHM Series Models 61-10134 FIGURE 22...
- Page 27 SMoGHoG reV: 17f ® SHM Series Models BASIC UNIT 04-001990...
- Page 28 SMoGHoG reV: 17f ® SHM Series Models REMOTE PANEL TOUCH CONTROLS 04-001802...
- Page 29 SMoGHoG reV: 17f ® SHM Series Models ADVANCED UNIT WITH REMOTE CONTROLS 04-002235...
- Page 30 SMoGHoG reV: 17f ® SHM Series Models 575:480 TRANSFORMER 04-001717...
- Page 31 this page intentionally left blank...
- Page 32 UAS is limited to furnishing replacement parts F.O.B. UAS’ factory or making repairs at UAS’ factory of any parts that are determined, upon inspection by UAS, to be defective. In no event will UAS be responsible for labor or transportation charges for the removal, reshipment or reinstallation of the parts.