Advertisement
Rigging a 1996 Ezzy Transformer Wave / Bump & Jump Sail
9)
Check that the camber is not over-rotated. This can fatigue the cam and the batten and lead to
possible breakage. If the cam is over-rotated, you need more downhaul.
10) Tension the tack strap until the edge of the sail beside the tack grommet touches the side of
the mast.
Quick Tip: The correct shape in the lower part of the sail will be attained when the tack-strap is fully
tensioned.
To Use As Full Batten:
1) Outhaul sail fully.
2) Release cam batten tension at leech end.
3) Release downhaul tension
4) Snap cam of mast (see # 5 above)
5) From the opening in the sleeve, pull out the
camber and batten.
6) From the leech end, insert the tapered end of
the batten into the lower batten pocket opening
(see diagram 8).
7) Tension the batten.
Page 3
Advertisement
