Page 1
INSTALLATION AND OWNER’S MANUAL Hydroponic Water Systems THIS MANUAL IS TO BE LEFT WITH THE OWNER OF THE EQUIPMENT FOR REFERENCE PURPOSES AND TECHNICAL GUIDANCE. IT IS STRONGLY RECOMMENDED THAT QUALIFIED DEALER SERVICE PERSONNEL BE CONTACTED IN THE EVENT OF AN UNKNOWN INTERRUPTION OF SERVICE OR APPARENT PRODUCT MALFUNCTION.
Please read this entire manual before attempting installation and operation. Section 1. Frequently Asked Questions Before getting started, take the time to familiarize yourself with your new Waterite system by reading some FAQs listed below. Call us or ask your dealer if you Excelgro+™...
A detailed warranty card is included with the unit. You may purchase an extended consumer warranty if you wish - see the enclosed Extended Warranty Program information sheet and enrolment form included in your package. Call your dealer or go to www.waterite.com to apply. Normal filter cartridge replacement is excluded from your warranty.
Page 4
Step 2. Getting Ready 1. Clear working area. Unpack all components and check for visual damage. Ensure all listed components are included. 2. You will need the following tools: An electric drill, a 1/8” drill bit, a pencil, a sharp knife for cutting tube (X-Acto type knife is best), a Phillips-head screwdriver, a center punch.
4. Connect the 3/8” tubing to the system permeate outlet (RO water). A shutoff valve is preassembled on the other end of the 3/8” tubing. 5. You may find that your unit does not have labels attached to indicate the water line and drain line connections.
Page 6
Total Dissolved Solids may be measured by a water professional or by use of a simple hand-held TDS meter. These are available from your dealer or from Waterite’s Online Store at www.waterite.com. Soft water free from iron is ideal for long membrane life. Hardness, iron, chlorine and infrequently changed filter cartridges are the membrane’s greatest enemies.
Section 4: Troubleshooting Guide Trouble Possible Cause Solution Low Water or No Water Water supply valve closed Open valves Low home water pressure Must exceed 40 PSI. If lower, install booster pump – see dealer Crimped poly tube Repair or replace tube Filters or membrane plugged Replace cartridges or membrane...
Page 8
(From the chart below) .5094 X 400 gallons = 203.8 gallons (771 litres) per day. 203.8 gallons/24 hours = 8.5 gallons (32.2 litres) per hour production rate VISIT THE WATERITE WEBSITE FOR INFORMATION, CONSUMER ONLINE REPLACEMENT PARTS AND PRODUCT UPDATES AT:...
Page 9
As additional protection for the RO from over-pressure and water hammer, your kit has been equipped with a combination water pressure reducer and water hammer arresting device, Waterite p/n REGP1414E. This device is installed on the cold water inlet tube that feeds the RO system. See figure 2.
Page 10
1.0 Install the REGP1414E device 1.1 Turn off the water supply to the cold water supply adapter. 1.2 Using a sharp knife or tube cutter, cut the ¼” tube between the Leak Stop device and the cold water inlet to the RO system. Make sure the cut is straight and without burrs. 1.3 Insert the tube from the cold water supply adapter into the inlet of the REGP1414E device.
Page 11
ADDENDUM 2 INSTALLATION INSTRUCTIONS FOR LEAK STOP FLOW INTERRUPTOR Waterite now includes a non-electric leak detection device, with all residential RO systems. This LEAK STOP is easy to install and will automatically shut off the incoming water being supplied to the RO unit if any water comes in contact with it.
Page 12
REGISTER YOUR PRODUCT ONLINE AT WATERITE.COM OR FILL OUT THE INCLUDED PRE-PAID, SELF ADDRESSED POSTCARD. WATERITE, INC. Winnipeg, Manitoba Canada www.waterite.com...