Safety Conditions - Fagor QC-PDS Hardware Manual

Read the following safety instructions in order to prevent harming people and damage to this product
or to the products connected to it.
MANDATORY Always use the latest reference (version) of this manual. It is available
on FAGOR's corporate website.
MANDATORY Refer to chapter 9 of this manual for any information on
SAFETY
of the QC-PDS system.
Bear in mind that besides the safety conditions indicated in this section, more conditions are described
throughout this manual either as requirements or marked with · SAFETY SYMBOLS ·.
Personnel qualification
The unit can only be repaired by personnel authorized by FAGOR AUTOMATION.
Only specialized technicians that know and understand the contents of this manual and all the
documentation related to the units may handle any of these units.
They must be trained on safety so they can identify and prevent any danger. Based on their technical
training, knowledge and experience, they must be able to foresee and recognize any possible danger
that may be caused by using these units, changing their settings and in general by the mechanical,
electrical and electronic devices that make up the whole system.
They must also know the current regulations and standards for preventing accidents that must be borne
in mind when handling these units.
FAGOR AUTOMATION shall not be held responsible of any physical or material damage originated from not
complying with these basic safety rules.
Forseen usage
 Destine the units to an industrial environment as instructed in this manual.
 Always comply with the safety standard in force at the location where the machine will be used, as
well as the environmental conditions specified and the technical data. See chapter 1. DESCRIPTION,
sections 1.6. AMBIENT AND OPERATING CONDITIONS and 1.7. ELECTRICAL CONDITIONS.
 Analyze risks related to the application before using the unit and take the proper safety
measures according to the results obtained.
 Ensure personnel safety anywhere in the system that these units belong to.
 Never use in explosive environments (dangerous areas).
Precautions against personal harm
 Never use damaged units.
 Use proper mains AC power cables.
To avoid risks, we advise using only the SERCOS and mains cables recommended for this unit.
Wrong wiring may cause unexpected movements in the system and cause personal injury.
 Avoid electrical overloads.
To avoid electric shocks and the risk of fire, do not apply electrical voltage beyond the range
indicated in this manual.
 Make the ground connection.
In order to avoid electric shocks, connect the ground bolt of this unit to the main ground terminal.
Also, before connecting the inputs and outputs, make sure that the ground connection has been
done.
 Make sure that the ground connection has been made.
In order to avoid electric shocks, make sure that the ground connections have been properly made
before turning the unit on.

SAFETY CONDITIONS

http://www.fagorautomation.com.
  Previous III
FUNCTIONAL
QC-PDS
HARDWARE
Ref.2003
· 19 ·