Sealey TA4000 Manual page 8

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1. GENERAL SAFETY
Connect the probe output to the TA4000

oscilloscope before connecting the probe to the
circuit under test. Disconnect the probe input and
the probe reference lead from the circuit under test
before disconnecting the probe from the TA4000
oscilloscope.
To avoid fire or shock hazard, observe all ratings

and markings on the product to be tested. Consult
the product manual for rating information before
making connections to the product. To avoid shock
hazard, use a correctly rated probe for your
measurement.
Remain vigilant when using the oscilloscope and

associated cables on, or near, machinery where
there are rotational parts such as belts, pulleys
and fans.
Maintain correct balance and footing. Ensure the

floor is not slippery and wear non-slip shoes.
Remove ill fitting clothing. Remove ties, watches,

rings, and other loose jewellery, and contain and/ or
tie back long hair.
DO NOT touch exposed connections and

components when power is on.
DO NOT connect or disconnect probes or test

leads whilst they are connected to a voltage
source.
Read and understand the manual for the TA4000

oscilloscope before using this cable set.
Original Language Version
INSTRUCTIONS FOR:
OSCILLOSCOPE PROBE
MODEL No:
2. INTRODUCTION
The TA4000.04 Oscilloscope probe is a passive, low
impedance attenuation probe intended for use with the
TA4000 Oscilloscope. The probe has been designed
and calibrated for use on instruments having an
impedance of 1MΩ paralleled by 20pF. However, it
may be recalibrated for use on instruments having an
input capacitance of 15 to 40pF. The probe comes
with a 1.5mtr cable and a two position slide switch
(1X, 10X) is incorporated into the probe body.
3. SPECIFICATION
Characteristic
Attenuation
Input Capacity
Oscilloscope
Input Capacity
Input Resistance
Band Width
Max Input Voltage
Probe Body Length
Coaxial Cable Length
Weight
TA4000.04
Performance Requirements
X1 X10
85pF~115pF 18.5pF~22.5pF
15pF~40pF
X1: 1MΩ ±2% X10: 10MΩ ±2%
X1: DC-6MHz
X10: DC-60MHz/100MHz/200MHz
X1: D>200V DC+Peak AC
X10: D>600V DC+Peak AC
Physical Characteristics
95mm
1200m
55g(max)n
TA4000 Issue: 1 - 06/09/11