ERVICING Your VWR Vortex Mixer is built for long, trouble-free, dependable service. It needs no user maintenance beyond keeping the surface of the top and the con- trol panel clean. Your Vortex Mixer should be given the care normally required for any electrical appliance. Avoid wetting or unnecessary exposure to fumes.
Page 4
IXED SPEED VORTEXER MIXER PECIFICATIONS Dimensions: 4.8"H x 6.8"W x 4.8"D (12.2cm x 17.3cm x 12.2cm) Voltage: 115v/230v AC, 50/60 hertz Current: 115v - 1.2 amps 230v - 0.6 amps Power: 150 watts Weight capacity: .65 lbs (294g) maximum Speed range - fixed speed: 3200rpm analog:...
Page 5
5. The intermittent "Auto" mode is intended for short mixing times of one minute or less at full speed. A rest period of 2 minutes is recommended to minimize the possibility of overheating the motor. Your Vortex Mixer can become warm to the touch with constant use. There is nothing wrong with it.
IGITAL ORTEX IXER PECIFICATIONS Dimensions: 4.8"H x 6.8"W x 4.8"D (12.2cm x 17.3cm x 12.2cm) Voltage: 115v/230v AC, 50/60 hertz Current: 115v - 1.2 amps 230v - 0.6 amps Power: 150 watts Weight capacity: .65 lbs (294g) maximum Speed range: 500 to 3000 rpm auto position: 1000 to 3000 rpm...
Page 7
5. The intermittent "Auto" mode is intended for short mixing times of one minute or less at full speed. A rest period of 2 minutes is recommended to mini- mize the possibility of overheating the motor. Your Vortex Mixer can become warm to the touch with constant use. There is nothing wrong with it.
ULSING ORTEX IXER PECIFICATIONS Dimensions: 4.8"H x 6.8"W x 4.8"D (12.2cm x 17.3cm x 12.2cm) Voltage: 115v/230v AC, 50/60 hertz Current: 115v - 1.2 amps 230v - 0.6 amps Power: 150 watts Weight capacity: .65 lbs (294g) maximum Speed range: 500 to 3000 rpm auto position: 1000 to 3000 rpm pulse mode: 3000 rpm...
Page 9
6. The intermittent "Auto" mode is intended for short mixing times of one minute or less at full speed. A rest period of 2 minutes is recommended to minimize the possibility of overheating the motor. Your Vortex Mixer can become warm to the touch with constant use. There is nothing wrong with it.
Insert foam rack into insert retainer by lining up recessed notches of foam with fingers of the insert retainer and sliding foam down until it reaches bottom. (Fig.1) Place insert retainer with foam rack on head mount of Vortex Mixer. (Fig.2) Follow Installing Head Attachments instructions.
Page 11
ANUFACTURED BY HENRY TROEMNER LLC 201 Wolf Drive PO Box 87 Thorofare, NJ 08086-0087 Phone: 856-686-1600 Fax: 856-686-1601 www.troemner.com email: troemner@troemner.com 715026-00 4-017-BRO Rev (12/04)
Need help?
Do you have a question about the Vortex Mixer and is the answer not in the manual?
Questions and answers