Table of Contents
Advertisement
Radio Operation
Presetting radio stations
You can preset 30 stations for FM and AM. Before tun-
ing, make sure that you have turned down the volume.
Press BAND on the remote control until FM or
1 1
AM appears in the display window.
With each press of BAND, FM and AM changes
2 2
alternately.
Press and hold TUNING
3 3
the front panel for about two seconds until the
frequency indicator changes, then release.
Scanning stops when the DVD/CD Receiver tunes in a
station. "TUNED" and "STEREO" (for stereo program)
appear in the display window.
ote
"TUNED" only appears when the signal is FM and
STEREO.
Press MEMORY on the front panel.
4 4
A preset number will flash in the display window.
Use TUNING
or
5 5
panel to select the preset number you want.
Press MEMORY on the front panel again.
6 6
The station is stored.
Repeat steps 3 to 6 to store other stations.
7 7
To tune in a station with a weak signal
Press TUNING
or
to tune in the station manually.
To clear all the stored stations
Press and hold MEMORY for about two seconds and
"CLEAR ALL" appear in the display window, then press
MEMORY again, the stations are removed from memo-
ry.
If you have accidentally entered into the "CLEAR
ALL" mode and you do not wish to clear the memory,
do not press any key. Wait. After a few seconds, the
"CLEAR ALL" display will go off by itself and change
to normal mode.
ote
If all stations slots have already been entered, the FULL
message will appear in the display window for a
moment and then a preset number will flash.
To change the preset number, follow steps 5-6 as above.
28
Listening to the radio
Preset radio stations in the DVD/CD receiver's memory
first (see "Presetting radio stations" on the left).
1 1
2 2
or
on
3 3
To turn off the radio
Press POWER to turn the DVD/CD receiver off or select
another function mode (CD/DVD or AUX).
To listen to non-preset radio stations
Use manual or automatic tuning in step 2.
For manual tuning, press TUNING
on the front
on the front panel repeatedly.
For automatic tuning, press and hold TUNING
panel.
To select a preset radio station directly
You can use the number buttons on the remote control
to select a preset radio station directly.
For example, to listen to preset station 4, press 4 on the
repeatedly in step 3
remote control. To listen to preset station 19, press 1
then 9 (within 3 seconds).
For your reference
If an FM program is noisy
Press MONO/STEREO repeatedly on the front panel
so that "STEREO" disappears in the display window.
There will be no stereo effect, but the reception will
improve. Press the button again to restore the stereo
effect.
To improve reception
Reorient the supplied antennas.
Press BAND repeatedly until AM or FM appears
in the display window.
The last received station is tuned in.
+/-
Press PRESET
repeatedly to select the pre-
set station you want.
Each time you press the button, the DVD receiver tunes in
one preset station at a time.
Adjust the sound by rotating VOLUME on the
front panel or by pressing VOLUME + or - on the
remote control repeatedly.
or
for about two seconds on the front
or
Advertisement
Table of Contents
