Wahl ST2200 User Manual page 5

ST2200 Soldering Iron Tester User Manual
Test Current:
LED Warning Indicator:
Millivolt Specifications:
Voltage Range:
Resolution:
Accuracy:
LED Warning Indicator:
Digital Display:
Output Jack:
Type:
Temperature:
Resistance:
Voltage:
Protection:
Auxiliary AC Outlet:
Auxiliary T/C Connector:
Wrist Strap Tester:
Voltage Spike Detector:
10 mA DC
Factory set at 5.00 Ohms. Switchable to 2.00 Ohms
via internal jumper (see section 6.1 for details).
0 - 30mV true RMS AC or AC+DC range.
Factory set at 0.01 mV. Switchable to 0.1 mV via
internal jumper (see section 6.1 for details).
±0.1mV ± 1 digit.
Indicates at 2.0mV threshold.
4-1/2 digit LCD, 0.7" high characters.
.101" Subminiature phone jack
1.0 mV/degree, ±5°F.
100 mV/Ohm for the 0-30 Ohm range, ±0.15 Ohm.
100mV/mV for the 0-30mV range, ±0.15mV.
Short circuit and Over Voltage protected.
Equipped with North American receptacle. Note:
220Volt models also equipped with North American
receptacle, marked as 220VAC.
Mini Type K thermocouple female connector
provided for use with optional T/C probes.
User selectable by front panel switch.
Activated in Resistance /Wrist Strap Test position.
Bi-color LED indicates Green when in acceptable
range of 500K to 10M ohms. Red when outside of
acceptable range.
Activated in both Millivolt ranges. Indicates green
in no-fault condition and flashes red for approx.
1 sec. when spike detected.
Page 5 of 34