Download Print this page

A.O. Smith MEV 50 EC Instruction Manual page 2

Advertisement

MEV 50 EC, MEV 80 EC, MEV 100 EC, MEH 50 EC, MEH 80 EC, MEH 100 EC
Trade mark:
A.O. Smith
Manufacturers no.:
MEV/MEH
Rated Voltage
230 Volt 50/60Hz
Rated input
2000/2500 Watts
Rated working pressure
800 kPa (8 bar)
Pressure relieve valve
800 kPa (8 bar)
Max. Thermostat setting
Thermal cut-out
MODELS MEV 50/80/100
MODELS MEH 50/80/100
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible fortheir safety.Children should be supervised to
A
DIVISON
ensure that they do not play with the appliance.
OF A.O.SMITH
CORPORATION
INSTRUCTION MANUAL
MODELS:
ELECTRICAL CONNECTION
1-Thermostat setting knob
2-Pilot light
3-Thermal cut-out reset knob
75ºC
4-Power supply connection
87ºC
5-Ground connection
6-Heating element
For safety purposes it is recommended to connect the water heater to the power
supply via a suitable double-pole switch, preferably provided with fuses.
Remove the cover at the bottom to access the electrical connections
Connect the ground conductor to the ground connection (5)
Connect the other two conductors to P1 and P2
Replace bottom cover.
LEGEND
1) Thermometer
2) Heating element
3) Anode
4) Cold water inlet pipe with diffuser
5) Hot water outlet pipe
6) Control thermostat and thermal cut-out reset button
7) Combination pressure relieve/check valve
8) Stop cock (not included with water heater)
9) Pilot light
10) Blue ring
11) Red ring
A.O.Smith Water Products Company B.V., De Run 5503 LW Veldhoven, PO Box 70 NL –5500
AB Veldhoven, Netherlands
Tel. +31 40 294 25 00 Fax. +31 40 294 25 09
E-Mail:Info@aosmith.nl. Internet:www.aosmithinternational.com,
407703-006 02

Advertisement

loading

This manual is also suitable for:

Mev 80 ecMev 100 ecMeh 50 ecMeh 80 ecMeh 100 ec