Triumph Tiger 900 Owner's Handbook Manual page 140

Maintenance
To adjust the front brake fluid level:
• Release the reservoir cap retaining
screws and remove the reservoir
cap and the diaphragm seal.
• Fill the reservoir to the UPPER level
line using new DOT 4 brake fluid
from a sealed container.
• Fit the diaphragm seal into the
reservoir cap and make sure that
the holes for the fixings in the
reservoir cap and the diaphragm
seal are correctly aligned.
1
3
1. Reservoir cap
2. Diaphragm seal
3. Reservoir cap retaining screw holes
• Install the reservoir cap retaining
screws into the reservoir cap and
diaphragm seal assembly.
140
• Hold
and position the reservoir cap,
diaphragm seal and reservoir cap
retaining screws onto the reservoir.
1
1. Reservoir cap, diaphragm seal and
reservoir cap retaining screws assembly
2
2. Reservoir
3
If the reservoir cap retaining screws
are over tightened this can result in a
brake fluid leak.
A dangerous riding condition leading
to loss of motorcycle control and an
accident could result if this warning is
ignored.
• Tighten the reservoir cap retaining
screws to 0.7 Nm.
the assembly
2
Warning
together