Before The First Use; Operating Sequence - Zanussi ZWF 14080 W User Manual

Follow the product manufacturers' instructions
on quantities to use.
Use less detergent if:
you are washing a small load,
●
the laundry is lightly soiled,
●
large amounts of foam form during washing.
●

Before the first use

WARNING!
Ensure that the electrical and water
connections comply with the installation
instructions.
IMPORTANT!
Remove the polystyrene block and any
material from the drum.

Operating sequence

as much as possible. Close the door.
Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
14
1. Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in the
drum, one item at a
time, shaking them out
Degrees of water hardness
Level Characteristic
1 soft
2 medium
3 hard
4 very hard
IMPORTANT!
Pour 2 litres of water into the main wash
compartment of the detergent drawer in
order to activate the ECO valve. Then run a
cotton cycle at 90°C or 95°C, without any
laundry in the machine, to remove any
manufacturing residue from the drum and tub.
Pour 1/2 a measure of detergent into the
dispenser drawer and start the machine.
and, if you wish to carry out a programme with
the prewash phase, pour it into the
compartment marked
If required, pour fabric softener into the
compartment marked
not exceed the «MAX» mark in the drawer).
Close the drawer gently.
Degrees
German French
°dH °T.H.
0-7 0-15
8-14 16-25
15-21 26-37
> 21 > 37
.
(the amount used must