Related Manuals for genz III Series
Summary of Contents for genz III Series
- Page 1 Product Manual Lithium Ferro Phosphate (LFP) Battery Module 48V 2kWh and 3kWh 2RU Scalable Energy Solutions Model Numbers GC48V-040LFP-2RU and GC48V-060LFP-2RU Series III with or without rack tray kit...
-
Page 2: Table Of Contents
APPENDIX B – CIRCUIT BREAKER TRIP CURVE (BS) ....................18 APPENDIX C – DIMENSIONS ..........................19 12.1 ............................. 19 ODULE AND 12.2 ............................. 21 ODULE AND APPENDIX D – WARRANTED OPERATING PARAMETERS ..................23 Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 2 of 25... -
Page 3: Introduction
Energy. Given that genZ Energy will continuously improve and develop the product, changes may be made to the information in this Manual at any time without obligation to notify any person of such revision or change. -
Page 4: Safety Guidelines
Repairs and Battery replacement must be performed by qualified service personnel only. Safety Data Sheet (SDS) Refer to the SDS that was supplied with this module in case of an accident. Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 4 of 25... -
Page 5: Specifications
The over voltage cut-out may vary from that stated. This is due to the fact that the BMS protects the internal cell string voltages ahead of overall pack voltage. Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 5 of 25... -
Page 6: Module Overview
NOTE: Before installing, ensure that the circuit breaker is in the down “OFF” position. Front Panel Knurled Knobs Knurled knobs are provided to assist in withdrawing the battery module from the battery shelf. Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 6 of 25... -
Page 7: Installation
A charger specifically designed for charging LFP’s must be used or the use of a charger that has configurable/programmable charging characteristics such that it meets the required profiles as detailed in this manual. If in doubt, please contact the provider of this battery module or contact genZ technical department for further guidance. -
Page 8: Installation Of A Single Battery Module
Series Connection These battery modules are NOT designed for connecting in series. Connecting in series will void your warranty as well as potentially creating a hazardous situation. Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 8 of 25... -
Page 9: Rackmount Configuration
J1. An alternate earth point is also located on the rear of the module. 4. Inspect for any damage to cables or connectors. 5. Connect the Power In/Out J1 connector by firmly pushing the plug straight into the socket. Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 9 of 25... -
Page 10: Connecting The Battery Module Operation
After two hours, the charging voltage can be removed as the module should now be fully charged. At the completion of the above charge profile, the battery can either be stored or placed on a float charge. Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 10 of 25... -
Page 11: Discharging The Battery Module
This ‘loss of capacity’ can normally be corrected by cycling the battery at least three times. Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 11 of 25... -
Page 12: Maintenance
LFP Battery Module – Product Manual Maintenance Unlike Lead Acid batteries, genZ Lithium Ferro Phosphate (LFP) battery modules are virtually maintenance free. There is no requirement to check fluid levels or salt deposit build up on battery terminals. It should be noted that it is outside of the scope of this manual to cover the variety of different systems and locations that the battery module(s) may be used in. - Page 13 CHECK AND INVESTIGATE REASON FOR OVER TEMPERATURE, IN PROTECTION HIGH TEMPERATURE MODE, OUTPUT OFF OTHER RETURN TO GENZ FOR SERVICE RECHARGE THE BATTERY AND RECHECK UNDER VOLTAGE, IN PROTECTION FOR CORRECT OUTPUT VOLTAGE MODE, OUTPUT OFF CHECK FOR SHORT CIRCUITS OR...
- Page 14 BATTERY MODULE IS LESS THAN EXCESSIVE CHARGE CURRENT 60AMPS. REFER TO INFORMATION/WARNING REGARDING STATE OF CHARGE OTHER RETURN TO GENZ FOR SERVICE INSUFFICENT CHARGE CHECK FOR FAULTY CHARGER, POOR VOLTAGE/CURRENT CABLING OR LOOSE CONNECTORS BATTERY MODULE FAILING TO CHARGE OR HOLD CHARGE...
-
Page 15: Warranty & Service Information
To ensure that you are covered by our 10 Year Limited Warranty, the purchaser shall follow the below requirements: o The battery module(s) have been purchased from genZ Energy, an authorised distributor, dealer or reseller o Overall system design shall be by a suitably qualified professional... -
Page 16: Warranty Or Service
In the unlikely event that you believe the module is faulty, contact the place of purchase or dealer/distributor first. If you cannot reach your dealer, or if they cannot resolve the issue please visit the genZ web site at www.genz.com.au for contact details for technical support. Please ensure that you have the following information available: Where and when the unit was purchased. -
Page 17: Appendix A - Discharge And Capacity Curves (25°C)
LFP Battery Module – Product Manual Appendix A – Discharge and Capacity Curves (25°C) Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 17 of 25... -
Page 18: Appendix B - Circuit Breaker Trip Curve (Bs)
LFP Battery Module – Product Manual Appendix B – Circuit Breaker Trip Curve (BS) Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 18 of 25... -
Page 19: Appendix C - Dimensions
LFP Battery Module – Product Manual Appendix C – Dimensions 12.1 2kWh Module and Tray Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 19 of 25... - Page 20 LFP Battery Module – Product Manual Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 20 of 25...
- Page 21 LFP Battery Module – Product Manual 12.2 3kWh Module and Tray Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 21 of 25...
- Page 22 LFP Battery Module – Product Manual Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 22 of 25...
-
Page 23: Appendix D - Warranted Operating Parameters
LFP Battery Module – Product Manual Appendix D – Warranted Operating Parameters Although genZ batteries are capable of performing at high rates and depths of discharge within a very wide temperature range, in order to achieve extended life cycles and to comply with the... - Page 24 LFP Battery Module – Product Manual Notes: Serial Number: Model Number: Place of Purchase: Date of Purchase: Owner: Issued for Use Revision Page All rights reserved genZ 2020 4/03/2020 24 of 25...
- Page 25 Energy Pty Ltd Western Australia Email: info@genz.com.au Web: www.genz.com.au...
Need help?
Do you have a question about the III Series and is the answer not in the manual?
Questions and answers