Display Functions; Illuminating The Display - BlueLine PowerCost Monitor Setup Manual

Display Functions

This is a short description of the Display Unit functions. For a full
description of each function, please read Section 7 in the User Guide.
CHANGING THE TEMPERATURE DISPLAY FORMAT
Press ˚C/˚F This button changes the temperature display from degrees
Celsius (˚C) to degrees Fahrenheit (˚F) and vice-versa.
CHANGING THE TIME OF DAY DISPLAY FORMAT
Press 12/24 This button changes the time display from 12-hour (AM/PM)
to 24-hour (military) format and vice-versa.

ILLUMINATING THE DISPLAY

Press LIGHT This button turns on the blue display backlight for 5 seconds.
ACTIVATING DOLLARS AND CENTS MODE
Press $ All values are displayed in either dollars and cents or cents
per kilowatt/hour (¢/kWh).
ACTIVATING KILOWATT MODE
Press KW All totals are displayed in either kilowatts (kW) or kilowatt/hours (kWh).
RESETTING THE CONSUMPTION TOTALS
Press CLEAR All consumption totals and consumption history peak values
are set to zero.
LOSS OF SIGNAL
In the event that your Display Unit loses the signal from the Sensor Unit,
the screen displays dashes instead of numbers.
1: Take your Display Unit it to your meter. Press and hold the SYNC button on
the front of the Display Unit until it beeps (approx. 3 seconds). The Display
Unit goes into ID Mode and it begins to search for your Sensor Unit.
2: Press and release the RESET button on the battery cover of the Sensor
Unit. The indicator light flashes and the Display Unit exits ID mode.
Your values should be appearing after a few minutes. If this is not the case,
see the Troubleshooting section in the User Guide.