BlueLine PowerCost Monitor Setup Manual page 6

8: Press SET
Your Day-of-Week segment is stored and the currently stored Kh value flashes.
9: Press OR Press-and-Hold or
Set your meter's Kh Factor.
Each button press increases or decreases the Kh value by 0.1.
Press-and-hold to change the value by increments of 1.0.
If you have an electromechanical meter, enter 7.2.
If you have an electronic meter, enter 1.0.
Now, from the two setup procedures below, select the one that is appropriate
for your billing mode (SINGLE or FLAT RATE, or TIERED RATE - for TIME
OF USE, please refer to section 6.5 of the User Guide).
SETUP SEQUENCE - Single (Flat) Rate Mode
10: Press SET
Your Kh value is stored. "1" is displayed under RATE, and the currently
stored value for Rate 1 flashes next to the ¢/kWh segment.
11: Press or
Set your electricity rate
Each button press increases or decreases the displayed Rate value by 0.1.
12: Press SET
Your Rate is stored. The THRESHOLD segment appears and the currently
stored Threshold flashes.
13: Press
SET THE THRESHOLD TO "0"
14: Press SET
Your electricity rate is now stored. The Display Unit quits Configuration
mode and is now fully configured for operation.