Controlling General Audio; Equalizer Control - Kenwood DDX9020DABS Instruction Manual

Controlling General Audio

1
Press the [MENU] button.
h Popup menu appears. h
2
Touch [Audio].
h Audio screen appears. h
3
Touch [Fader / Balance].
4
Set each parameter as follows.
[Fader / Balance]
■
Adjust the volume balance around the
touched area.
[C] and [D] adjust the right and left volume
balance.
[R] and [S] adjust the front and rear volume
balance.
■ [Center]
Clear the adjustment.
NOTE
• When the 3-way speaker system is selected,
"Fader" adjustment is disabled.

Equalizer Control

You can adjust equalizer by selecting the
optimized setting for each category.
1
Press the [MENU] button.
h Popup menu appears.
h
2
Touch [Audio].
h Audio screen appears. h
3
Touch [EQ / SW Level].
4
Touch the screen and set the Graphic
Equalizer as desired.
Gain level (area in dotted frame)
■
Adjust the gain level by touching each
frequency bar.
You can select a frequency bar and adjust its
level by [R], [S].
[Preset Select]
■
Display the screen for selecting the preset
equalizer curve. (P.82)
■ [Memory]
Saves the adjusted equalizer curve as "User1"
to "User4". (P.82)
■
[Initialise]
Initialize (flatten) the current EQ curve.
[ALL SRC]
■
Apply the adjusted equalizer curve to all
sources. Touch [ALL SRC] and then touch
[OK] on the confirmation screen.
[Bass EXT] (Bass Extend Settings)
■
When turned on, the frequencies lower than
62.5 Hz is set to the same gain level (62.5 Hz).
Controlling Audio
81
English