Table of Contents
Advertisement
ONLINE ELECTRONICS LTD
3.9. EXTERNAL CONNECTIONS
The instructions detailed within the product certificate
and section 7 CERTIFICATION APPENDIX of this
manual must be followed at all times.
Remove the endcap as described in section 3.7
OPENING
THE
ENCLOSURE
to
reveal
the
PCB
connections.
All
connections
are
made
using
5.08mm
pitch
removable terminal blocks which can accept up to
2.5mm
2
(12AWG) wire size. All connections must be
made using suitable crimp ferrules. Connections are
clearly labelled on the PCB and have the functions
described in the following sections.
An example of the recommended wiring for an ID5002P system is shown below.
ID5002P MANUAL RevA01
Page 16 of 21
Advertisement
Table of Contents
