Advertisement
Finishing:
The whole airframe is covered in 12gr japan paper and doped with filler dope, DO NOT USE SHRINKING
DOPE EVER.
Filler dope is not too hard to sand, and filled with some extra talcum powder sands great and smooth,
when ready a thinned layer of sanding dope is OK
Now finish with... Vallejo, humbrol or we used cheap spray cans... take care for the vacuumformings as
some paints will not hold as good, or worse will dissolve or make it brittle
Canopy:
Cut oversize... And test fit to fuselage, glue with canopy glue, or ca and make it lively with pilot, radios,
etc. The canopy framing can be painted on
Have you found an error in the drawing or parts or instructions, just mail us at
info@rbckits.com
I am sure we can find a solution for your build.
Some tips:
We used electric retracts for the F35 90mm, and we used a separate battery for the retracts this makes
it safer, air set is also possible, the weight difference is none
Flying:
The F35 90mm easy lifts of and is easy to fly you do not need flaps for take-off! (this does not work
flaps gives a nose heavy moment), landing: plan it in and land it as usual but do not make it to slow
.the F35 90mm glides very well with wheels in in case of ....
A 6S battery is powerful enough, 8S possible or Turbine
Throws of the rudders etc., we like them big, but it might be too much so always, make them large and
have a dual rate button in your fingers, to small throws is most of the time problems, to large... it is in
your fingers
If you need additional pictures, just ask.
Have Fun with the F35 90MM
Additional pictures are on the disk , also a 3d pdf , where you can see all parts of the F35 90mm in 3d ,
you need adobe 10X to view, it will not work in your browser
WWW.RBCKITS.COM
Rontgenweg 16G
2408AB Alphen aan den Rijn
Netherlands
Advertisement
