Table of Contents
Advertisement
2 Safety information
The safety information in this document refers only to an in-
dividual product. Potentially dangerous conditions can arise
in combination with other plant components, which need to
be considered on the basis of a risk analysis. The operator is
responsible for the production of the risk analysis and for
compliance with the resulting precautionary measures and
regional safety regulations.
The document contains fundamental safety information that
must be observed during commissioning, operation and
maintenance. Non-compliance with these instructions may
cause:
–
Personal hazard due to electrical, mechanical and
chemical effects.
–
Hazard to nearby equipment.
–
Failure of important functions.
–
Hazard to the environment due to the leakage of dan-
gerous materials.
The safety information does not take into account:
–
Unexpected incidents and events, which may occur
during installation, operation and maintenance.
–
Local safety regulations which must be adhered to by
the operator and by any additional installation person-
nel.
Prior to commissioning:
1. Transport and store the product correctly.
2. Do not paint the bolts and plastic parts of the product.
3. Carry out installation and commissioning using trained
personnel.
4. Provide adequate training for installation and operating
personnel.
5. Ensure that the contents of the document have been fully
understood by the responsible personnel.
6. Define the areas of responsibility.
7. Observe the safety data sheets.
8. Observe the safety regulations for the media used.
During operation:
9. Keep this document available at the place of use.
10. Observe the safety information.
11. Operate the product in accordance with this document.
12. Operate the product in accordance with the specifica-
tions.
13. Maintain the product correctly.
14. Do not carry out any maintenance work and repairs not
described in this document without consulting the manu-
facturer first.
In cases of uncertainty:
15. Consult the nearest GEMÜ sales office.
www.gemu-group.com
3 Manufacturer's information
3.1 Delivery
● Check that all parts are present and check for any dam-
age immediately upon receipt.
The product's performance is tested at the factory. The
scope of delivery is apparent from the dispatch documents
and the design from the order number.
3.2 Transport
1. Only transport the product by suitable means. Do not
drop. Handle carefully.
2. Avoid knocks and vibration.
3. Dispose of transport packing materials according to rel-
evant local or national disposal regulations/environ-
mental protection laws after installation.
3.3 Packaging
The product is packed in a cardboard box which can be re-
cycled as paper.
3.4 Storage
1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their
spare parts.
5. Store the product with the connections blocked off.
4 Product description
4.1 Construction
Fig. 1: Main components of instrument sensor
Item
1
2
3
5 / 20
4 Product description
Name
Instrument sensor
Plug
Locking screw
GEMÜ 127x
Advertisement
Table of Contents
