Door Reversal - Zanussi ZFE 102/3T Instruction Booklet

DOOR REVERSAL

The appliance is normally supplied with doors which
open from left to right. To change the opening
direction, proceed as follows:
Bottom door:
1. Unclip and remove the ventilation grille (A).
2. Unscrew and remove the lower hinge (B) and
slide the lower door from its top hinge.
3. Unscrew the pin (C) from the hinge and refit it
onto the hinge on the opposite side.
4. Refit the lower door onto pin (C) and reassemble
the lower hinge (B) on the opposite side.
5. Break off the plug (D) from the ventilation grille.
You may need a pair of pliers for this.
6. Fit the plug (E) (supplied with the appliance) into
the slot left open on the other side.
7. Refit the ventilation grille (A) clipping it into
position.
Fig. 3
L
G
I
C
B
3P 06
6
D
Top door:
1. Unscrew the hinge (G) and remove the upper
door.
2. Unscrew the pin (I) from hinge (G) and refit the
pin into the same hole, but on the opposite side of
the hinge.
3. Unscrew the pin (L) from the upper hinge and
refit it in the hinge on the opposite side.
4. Fit the upper door onto the pin (L); refit hinge (G)
on the opposite side.
Adjusting the alignment of the upper door
If, after having changed the opening direction, the
door is not properly aligned, the upper hinge can be
adjusted. To do this, slacken the pin (L) (using a 12
mm spanner) and the self-tapping screw located
under the hinge (using a Phillips screwdriver); align
the door, then retighten the screw and the pin.
B
A
L
I
G
C
E