Table of Contents
Advertisement
INSTALLATION
If this refrigerator featuring magnetic door seals is to
replace an older appliance having a spring lock on the
door or lid, be sure to make that spring lock unusable
before you discard the old appliance.
This will prevent it from becoming a death-trap for a
child.
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature between +18 C and +43 C (class T);
+18 C and +38 C (class ST); +16 C and +32 C (class
N); +10 C and +32 C (class SN).
The class of your appliance is shown on its rating
plate.
Make sure that there is nothing hindering air
circulation at the back, bottom, or top of the
appliance.
To achieve the best performance when the
appliance is set under a wall cabinet the top of the
appliance should be at least 5 mm away from the
base of the cabinet (Fig. 1/A).
However, the appliance should ideally not be
installed underneath wall cabinets (as shown in
Fig. 1/B).
One or more adjustable feet mounted on the base of
the appliance make it possible to set it perfectly
level.
min.
2
50 cm
A
B
min.
min.
2
2
50 cm
50 cm
D584
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted as shown in the figure 2.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
12
Fig. 1
PR153
Power connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by 6% of the rated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with EEC directive number
87/308 of 2/6/87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Cleaning the appliance's interior
Before using the appliance for the first time, wash
all internal parts with lukewarm water and neutral
soap so as to remove the typical «new» smell and
then drv thoroughly.
Do not use detergents or abrasive powders as these
will damage the finish.
Fig. 2
Advertisement
Table of Contents
