Fig.7
4.9.
Unscrew and remove the injection drive to release the air inside the tube. (See fig.7).
4.10.
Repeat instructions from 4.1 to 4.8 a couple of times to make sure the resin fully injects into the chip area. Clean the injection tube and
pressure drive of any glue residue.
Fig.9
4.11.
Remove the suction support set and clean away the excess resin.(See fig.8).
4.12.
If the repair is still visible drop a small amount of repair resin on the damaged area.
4.13.
Lay a curing strip over the top of it. Make sure there is no air left under the curing strip. (See fig.9).
4.14.
Leave the vehicle in direct sunlight or use UV light for 5-10 minutes to dry. DO NOT remove the curing strip until the resin is dry.
4.15.
Use the razor blade to scrape away the excess resin. (See fig.10).
4.16.
If left to dry in overcast conditions the resin can take up to one hour to cure.
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to : www.sealey.co.uk,
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey Limited
email: sales@sealey.co.uk or phone: 01284 757500
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
Fig.8
Fig.10
01284 757500
01284 703534
www.sealey.co.uk
W e b
sales@sealey.co.uk
email
WK01
Issue No.1 - 05/12/13