Power Supply Units; Cleaning And Care; Service - Hettich Mosys Operating Instructions Manual

If the remote control is not used over a longer period of time, the batteries should be
removed in order to avoid possible damage that may otherwise be caused by leaking
batteries.
If you lose the RF remote control or in case of a power failure (only if the bed uses the
power supply unit SMPS NAS, see 7.3) the bed can be returned into the lying position
by pressing the reset button (see illustration 10 "H") at the control unit.
This radio system is allowed to be used within the entire European economic region.
Class I system.

7.3 Power supply units

When using the SMPS NAS (emergency lowering), the battery has to be connected in the
battery compartment.
The 9 V block battery only serves the purpose of an "emergency lowering" of the system,
i.e. if a power outage system error should occur, it is still possible to adjust to a lying
position.
NOTE
The battery is not intended to be used to raise the system!

8 Cleaning and care

A guarantee for a perfect working condition and battery reliability can only be provided
when the drive unit is used correctly and the instructions and respective regulations
specified in the operating manual are observed.
DANGER
Danger due to electrical current!
Completely disconnect the drive unit from the electrical network by removing the power
plug from the mains before performing care and cleaning tasks (ensure zero potential)
 Never bring the drive unit into contact with water. Possible infiltration of water and
contact with electrical components can negatively influence the correct operation and
seriously impair the protection against electric shock.
Customary cleaning and care products for plastic (polyamide 6) and for galvanised steels
are to be used under observation of the respective manufacturers' instructions.
Under no circumstances should you use abrasive, chemically aggressive or corrosive
cleaning products or hard cleaning brushes. The drive unit is practically maintenance-free.

9 Service

Service and maintenance operations are only allowed to be performed by respectively
trained staff. If you need repair, spare parts and accessories, please contact your supplier.
Other language versions of the operating instructions can be found under
www.hettich-franke.com
(see illustration 8/9)
19