SoundCraft SM 16 User Manual page 42

SPECIFICATION NOTES AND CONDITIONS
A The Console has a nominal output level of +4dBu: all input sensitivities are
relative to this, i.e., with line input gain set to '0', an input of 0dBu will give an
output of +4dBu at any group or mix output, and a sensitivity of +4dBu gives unity
gain from input to output.
B Noise measurements are taken with 22Hz-22kHz bandwidth, rms-reading
response.
C Distortion measurements are made with a an input of +20dBu (line inputs at
unity gain) giving an output of +20dBu. The analyser reads THD+N with an average
response over a 10Hz-30kHz bandwidth.
D Frequency response and EQ measurements are made with an input of 0dBu to
line inputs at unity gain: outputs are quoted relative to 0dBu.
E Crosstalk and rejection measurements are made with an input level of +20dBu
(line inputs at unity gain) giving an output of +20dBu on the active signal path. The
ratio quoted is relative to +20dBu output.
F Gain tolerance is +/- 1.5dB or 10% of the indicated value, whichever is the
greater.
G Group Noise: noise measured at the group output with faders at unity, and
channel send pots down.
H Mix Noise: noise measured at the stereo mix output with faders at unity, and
channel sends off.
38 Appendices