Table of Contents
Advertisement
Gateway
The gateway parameter is an IP address that provides routing information to
the T464. The T464 default settings will allow a DHCP server to configure this
information. This gateway IP may be entered manually and is necessary if the
administration terminal resides on a different subnet to the T464.
Other Parameters
The Network parameters display also shows a DNS Server IP and a
DHCP device name setting. These default values are not required to be
changed in this software release.
Manually configure IP, Subnet Mask and Gateway
If the 'Manually configure IP, Mask and Gateway' option is selected, the user
will be prompted to enter three values:
• IP: the IP address to be assigned to the T464.
• Subnet Mask: the subnet mask defining the network segment on which
the T464 resides. (Quads must be 3 numerals.)
• Gateway: the gateway IP address for access to the administration
terminal, if it resides on a different subnet.
The following panel illustrates configuration of network options:
Manually configure IP, Subnet Mask and Gateway? y/n: y
IP : (enter to keep current:) :.0.0.0.0
IP : (enter to keep current:) :0.0.0.
IP : (enter to keep current:) :0.0.0.256
IP : (enter to keep current:) :00..000.000.000
IP : (enter to keep current:) :000.000.000.00.
IP : (enter to keep current:) :0.0.0.0
Store IP:0.0.0.0 y/n
Subnet Mask: (enter to keep current:) :0.0.0.0
Please use xxx.xxx.xxx.xxx format.
Subnet Mask: (enter to keep current:) :255.255.245.000
Subnet Mask IP:255.255.245.000 y/n
Warning: invalid Subnet Mask:255.255.245.000 See manual.
Subnet Mask: (enter to keep current:) :255.255.255.255.
Please use xxx.xxx.xxx.xxx format.
Subnet Mask: (enter to keep current:) :y
Please use xxx.xxx.xxx.xxx format.
Subnet Mask: (enter to keep current:) :255.255.255.000
Subnet Mask IP:255.255.255.000 y/n
Gateway IP: (enter to keep current:) :
Keeping Gateway:
IP: 0.0.0.0
NM: 255.255.255.000
GW: Not set. Using default 000.000.000.000
Set network parameters listed above? y/n: y
Network parameters set. Exiting via Restart...>
Example of Manual Network Parameter Configuration and prompts
20090709 v1r0 JED Microprocessors Pty. Ltd. - Page 11 of 27
T464 Installation and Setup
-missing quad
-bad length 6
-quad too big 256
[hit 'y' to save]
[each quad must be 3 numerals]
[zero bits:8] - Stored.
-missing quad
-too many dots 4
[hit 'y' to save]
Advertisement
Table of Contents
