Something Not Working - Zanussi ZCM 610 X Instruction Booklet

Something not working

If the aplliance is not working correctly, please carry out the following checks, before contacting your local
Zanussi Service Centre.
IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or
installation, a charge will be made even if the appliance is under guarantee.
SYMPTOM
There is no spark when lighting the gas
The gas ring burns unevenly
The oven does not come on
The oven temperature light does not come on
The oven light does not come on
It takes too long to finish the dishes, or they are
cooked too fast.
Steam and condensation settle on the food and the
oven cavity.
The timer does not work
The oven fan is noisy
20
SOLUTION
Check that the unit is plugged in and the electrical
supply is switched on
Check that the RCCB has not tripped (if fitted)
Check the mains fuse has not blown
Check the burner cap and crown have been
replaced correctly, e.g. after cleaning.
Check the main jet is not blocked and the burner
crown is clear of food particles.
Check the burner cap and crown have been
replaced correctly, e.g. after cleaning.
Check the oven is in manual operation and that
both a cooking function and temperature have been
selected.
Check the oven is wired in properly, and the
socket switch or the switch from the mains supply to
the oven are ON.
Select a temperature with the thermostat control
knob
Select a function with the oven function control
knob.
Check the light bulb, and replace it if necessary
(see "Replacing the Oven Light")
The temperature may need adjusting
Refer to the contents of this booklet, especially to
the chapter "Using the Oven".
Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed.
Check the instructions for the timer.
Check the grease filter is correctly fitted.
Check that shelves and bakeware are not vibrating
in contact with the oven back panel.