Connecting To Gas Supply - Zanussi ZCG7551 User Manual

Important: The wires in the mains lead fitted
to the appliance are coloured in accordance
with the following code.
Green and yellow
Blue
Brown
As the colours of the wires in the mains lead
of this appliance may not correspond with
the coloured markings identifying the
terminals in your plug, proceed as follows:-
The wire which is coloured green and yellow
must be connected to the terminals in the
plug which is marked with the letter E or by
the earth symbol (
green and yellow.
coloured blue, must be connected to the
terminal which is marked with the letter N or
coloured black. The wire which is coloured
brown, must be connected to the terminal,
which is marked with the letter L or coloured
red.
Ensure that the cable does not become
trapped when pushing the appliance into
position.
If a moulded plug is fitted.
In the event of replacing a fuse in the plug
supplied a 3 amp ASTA approved fuse to
B.S. 1362 must be fitted.
Note: The fuse cover must be refitted when
changing the fuse. In the event of losing the
fuse cover the plug must not be used until a
replacement fuse cover has been obtained
and fitted.

Connecting to gas supply

This appliance is designed to be installed
with an appliance flexible connection only.
Supply piping should not be less than R
Connection is made to the Rc ½ (½" B.S.P.)
female threaded entry pipe located just
below the hotplate level on the rear left hand
side of the appliance. NOTE: ONLY LIQUID
SEALANTS TO BE USED WHEN INLET
GAS PIPE IS FITTED I.E.: DO NOT USE
P.T.F.E. SEALANT TAPE.
40
-Earth
-Neutral
-Live
) or coloured green or
The wire which is
/8.
3