Table of Contents
Advertisement
CAUTION:
USAGE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULTE IN HAZARDOUS RADIATION EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE
PERSONNEL.
WARNING:
-
THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING AND THAT NO
OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHALL BE PLACED ON THE APPARATUS.
-
BATTERIES (BATTERY PACK OR BATTERIES INSTALLED) SHALL NOT BE EXPOSED TO
EXCESSIVE HEAT SUCH AS SUNSHINE, FIRE OR THE LIKE.
-
THE MAINS PLUGS OR AN APPLIANCE COUPLER IS USED AS THE DISCONNECT DEVICE, AND
THE DISCONNECT DEVISE SHALL REMAIN READILY OPERABLE.
PRECAUTIONS FOR USE
INSTALLATION
UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
•
DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS VOLTAGE AND BEFORE
•
ALL OTHER CONNECTIONS HAVE BEEN MADE.
DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS
•
AROUND THE UNIT FOR VENTILATION.
CONNECTION
3.
CONNECT EXTERNAL POWER ADAPTOR TO EXTERNAL POWER ADAPTOR JACK
4.
PUSH THE STANDBY KNOB TO SWITCH ON THE UNIT, STANDBY INDICATOR (RED COLOR) WILL BE OFF.
IF THE BACKLIGHT ON THE LCD DISPLAY LIGHTS UP, IT MEANS THE POWER SUPPLY IS NORMAL, NOW
YOUR SYSTEM IS READY FOR USE.
SETTING THE CLOCK
5
WHEN THE STANDBY INDICATOR (RED COLOR) LIGHT UP, UNIT IS IN THE STANDBY MODE.
6
DURING STANDBY MODE, SELECT BETWEEN 12H OR 24H MODE: PRESS AND HOLD CLK BUTTON FOR
3-5 SECONDSS, 12H / 24H WILL BE FLASHING. PRESSING SKIP UP OR SKIP DOWN BUTTON TO SELECT
12H / 24H MODE. PRESS CLK BUTTON AGAIN TO CONFIRM.
7
SETTING HOUR: PRESSING SKIP UP OR SKIP DOWN BUTTON TO SELECT THE CORRECT HOUR, THEN
PRESS CLK BUTTON AGAIN TO CONFIRM.
8
SETTING MINUTE: AFTER STEP 3 IS COMPLETED, PRESSING SKIP UP OR SKIP DOWN BUTTON TO
SELECT THE CORRECT MINUTE, THEN PRESS CLK BUTTON AGAIN TO CONFIRM.
SETTING ALARM
5.
DURING STANDBY MODE, HOLD TIMER BUTTON FOR 3-5 SECONDS. SETTING ALARM SEQUENCE IS
"ALARM ON TIME > ALARM OFF TIME > ALARM MODE > ALARM VOLUME".
6.
SETTING ALARM ON TIME: "ON" IS LIGHTING ON THE DISPLAY
i.
SETTING HOUR: PRESSING SKIP UP OR SKIP DOWN BUTTON TO SELECT THE CORRECT
HOUR, THEN PRESS TIMER BUTTON AGAIN TO CONFIRM.
ii.
SETTING MINUTE: PRESSING SKIP UP OR SKIP DOWN BUTTON TO SELECT THE CORRECT
MINUTE, THEN PRESS TIMER BUTTON AGAIN TO CONFIRM.
7.
SETTING ALARM OFF TIME: "OFF" IS LIGHTING ON THE DISPLAY:
i.
SETTING HOUR: PRESSING SKIP UP OR SKIP DOWN BUTTON TO SELECT THE CORRECT
HOUR, THEN PRESS TIMER BUTTON AGAIN TO CONFIRM.
ii.
SETTING MINUTE: PRESSING SKIP UP OR SKIP DOWN BUTTON TO SELECT THE CORRECT
MINUTE, THEN PRESS TIMER BUTTON AGAIN TO CONFIRM.
8. SETTING ALARM MODE: "TUNE" IS LIGHTING UP ON THE DISPLAY:
i.
PRESSING SKIP UP OR SKIP DOWN BUTTON TO SELECT THE ALARM MODE.
15 -
W
Advertisement
Table of Contents
