Table of Contents
Advertisement
III) COPY ALL TRACK
1.INSERT THE USB STORAGE MEDIA OR SD/MMC CARD, SET IN CD & STOP MODE AFTER UNIT READING.
2. PRESS REC BUTTON, THEN "ONE" WLL BE FLASHING ON THE DISPLAY. PRESS SKIP UP
BUTTON TO SELECT "ALL" ON THE DISPLAY. PRESS
4. USB OR SD ICON WILL BE FLASHING ON THE DISPLAY. COPYING IS PERFORMING NOW.
5. WHEN THE USB OR SD ICON STOPS FLASHING, IT MEANS THAT ALL TRACK COPYING IS COMPLETED.
SPLIT TRACK FUNCTION FOR USB/SD RECORDING FOR TURNTABLE/AUX IN
1)
MANUAL SPLIT OPERATION PROCEDURE: DURING USB/SD RECORDING, THE USB/SD ICON WILL
FLASH ON THE DISPLAY. IF A NEW TRACK IS REQUIRED, PRESS MODE BUTTON ON THE UNIT OR REMOTE
CONTROL, DISPLAY WILL SHOW "TS", THEN THE UNIT WILL STOP RECORDING MOMENTARILY AND RESUME
AGAIN. A NEW FILE WILL HAVE BEEN CREATED ON THE USB/SD DEVICE REPRESNTING A NEW TRACK.
2)
AUTO SPLIT OPERATION PROCEDURE:
-
BEFORE USB/SD RECORDING, SELECT AUDIO SOURCE, THEN PRESS MODE BUTTON ON THE UNIT
OR REMOTE CONTROL, DISPLAY WILL SHOW "T-ON", WHICH MEANS THE AUTO SPLIT FUNCTION HAS
ACTIVATED. THEN START USB/SD RECORDING, THE UNIT CAN AUTOMATICALLY DETECT THE SILENT PART
BETWEEN EACH TRACK, AND CREATE A NEW FILE TO MOVE ON TO START RECORDING THE NEXT TRACK.
-
IF NOT REQUIRED: PRESS MODE BUTTON ON THE UNIT OR REMOTE CONTROL BEFORE USB/SD
RECORDING, DISPLAY WILL SHOW "T-OF", WHICH MEANS AUTO SPLIT HAS BEEN DEACTIVATED.
-
PLEASE NOTE FOR AUTO SPLIT: SEVERAL SECONDS OF THE BEGINNING OF THE NEXT TRACK MAY
NOT BE RECORDED, AS THE UNIT MAY TAKE A FEW SECONDS TO CREATE A NEW FILE ON THE USB/SD;
AND IT CAN ADDITIONALLY BE THE CASE THAT SOME MUSIC PRODUCERS INTENTIONALLY ADD SILENT
SECTIONS WITHIN ONE TRACK. AS A RESULT, THIS WILL VERY LIKELY MAKE THE UNIT CONSIDER THIS
SILENT PART THE BREAK BETWEEN TRACKS AND CREATE A NEW TRACK ON THE RECORDING.
-
NOTE FOR AUTO SPLIT: DURING USB/SD RECORDING FROM TURNTABLE, WHEN THE UNIT HAS
DETECTED ANY PARTICULAR SILENT PART, THE TURNTABLE WILL STOP MOMENTARILY. THE TURNTABLE
WILL RESUME OPERATION ONCE THE USB/SD DEVICE HAS BEGUN CREATING A NEW FILE TO BE
RECORDED.
EARPHONE JACK & LINE OUT SOCKET
THIS SYSTEM CAN BE CONNECTED WITH HEADPHONE OR EXTERNAL AMPLIFIER /
-
SPEAKER BY 3.5MM EARPHONE JACK.
THIS SYSTEM CAN BE CONNECTED WITH EXTERNAL DEVICE (EG. AMPLIFIER AND
-
SPEAKER) BY LINE-OUT SOCKET AT REAR CABINET.
POWER SAVING
FEATURE:
To save energy, if there is no audio signal from CD / Turntable / AUX IN / USB / SD for a period of over 10 minutes,
then the unit will automatically switch to Standby Mode.
REC
BUTTON AGAIN TO CONFIRM.
/ SKIP DOWN
22 -
W
Advertisement
Table of Contents
