Page 1
WARNING • Warning is signal that lets people know the possible risks and tells people who drive this vehicle to operate by following the right instrustions to avoid accidents. • Operation of this ATV by children un der the age of 12 lncrease of the risk of severe injury ordeath •...
FOREWORD Table of Contents Thank you choose this all terrain vehicles Pay attention to your security........... The all-terrain vehicle is based on market demand, production Guidelines on safe driving............of a comprehensive survey. We hope that it will bring you Description................
Page 3
PAY ATTENTENTION TO YOUR SAFETY 11. Check ATV before using every time, make sure it is in safe ATV is not a toy, driving may cause danger. The operation of ATV sitation,operate the inspection、maintenance method and time is different from other motorcycles、automobiles and so on table in the instructions vehicles.
GUIDELINES ON SAFE DRIVING 19. When drive to the hillside, always use properly according to correct procedures required in instructions. Avoid over-smooth or soft terrain, in accordance with the rules mentioned in manuals. ☆WARNING Center of gravity to the high side. With the slope driving, do not spin You could be KILLED or SERIOUSLY INJURED if do not follow until master turning skills on flat roads described in the manuals.
2 、 Contact with local sales agent, search for training classes nearby, and do (7)Front gnard some necessary training. You can also watch our COOLSTER ATV Safety Video for more security informations ,please do not drive this ATV until you get some appropriate guidance.
Page 6
ATV-Safety Alert The warning signs with the word"WARNING" indicating the existence of the potential risks that may result in serious injury or The Consumer Product Safety Commission has concluded that ALL-TERRAIN death. VEHICLES (ATVs) may present a risk of DEATH or SEVERE INJURY in certain circumstances.
• NEVER ALLOW A CHILD UNDER 16 YEARS OLD TO OPERATE AN ATV ATV RECOGNITION WITHOUT ADULT SUPERVISION. CHILDREN NEED TO BE OBSERVED CAREFULLY BECAUSE NOT ALL CHILDREN HAVE THE STRENGTH, SIZE, SKILLS OR JUDGEMENT NEEDED TO OPERATE AN ATV SAFELY. •...
CONTROL FUNTIONS REMOTE CONTROL 1、The ignition switch The ATV comes equipped with a remote control which isconsist of Location Functions Key state a purple Flameout key and a black unlock key. An adult supervising Pull out All circuits wre disconnected operation of the vehicle can use the remote control to stop the engine from a short distance.
Page 9
4、The front wheel brake handle 7、Choke Resistance carburetor throttle in the right arm. Front-wheel brake Starting cold engine needs a concentration of handle in the right combustible gas concrete. In such circumstances, hands. To handle its will be impacted throttle arm moving down. After direction pinch Rafah as preheating the engine will pull rod to the original a front-wheel brake.
BEFORE THE INSPECTION OPERATION DRIVERS MUST Prior to the use of the car, should check the following Fuel: Item Normal checks fuel compartment confirm the adequacy of fuel. Brake nspection operation, status and freedom Warning: itinerary. If necessary,should be adjusted. ●...
Page 11
Oil: TIRES Oil confirm whether oil at the designated place. (See left picture) 1. Tire pressure Before the cars in operation, should always check and adjust 1, the maximum oil level.2, the lowest of oil. (See right picture) tire pressure. (Tires Barometer) 2.
IMPORTANT ELEMENTS OPERATIONAND RIDES The acceleration engine Cold Start and engine preheating Because the cars use Automatic Clutch. So acceleration and deceleration size only need to control the throttle on the up. Note: This car has used to control the operation of brake According to the former right hand thumb of increased speed, motor starter switch.
Full Throttle or any situation Note: If you are not familiar with this vehicle maintenance that could be the super-engine overheating. services, the work should be COOLSTER maintenance station. 1,0 150 km: Regular maintenance / lubrication Operation and avoid prolonged refueling over 1 / 4 throttle position.
Page 14
37 - 79 ☆ ☆ ☆ Battery* necessary, the correction should be carried out 8-12 73 - 115 *: We propose that these items should be COOLSTER repair station for maintenance services. **: Medium weight wheel 16- 26 146- 205 bearing grease.
Page 15
C. The oil should be located at the highest and the lowest COOLSTER dealer or repair shop for repair. among the oil-marker. If the oil level low, should be enough oil 3, after the test should be tightened release oil bolts.
Page 16
Crankcase emission filter of the circulatory system Air Filters Filters should carry out regular checks, cleaning. If necessary, replaced. The throttle cable adjustment Locked nut Adjuster 1、the part works for 150 hours, please cleaning to make the part to use normaly. 2、take out filter of oil and gas separator, using gasoline or kerosene to carry out the washing, and drying.
Page 17
Brown. Do not attempt to self-diagnosis of the dealer or repair shop to adjust any fault, and should be sent to COOLSTER the car dealer or brake shoes. repair shop. You must be regularly removed and examined...
Page 18
The drive chain adjustment The drive chain lubrication The chain includes many mutual operation of the parts. If the chain would not carry out proper maintenance, the chain that will soon wear. Therefore, we must carry out regular maintenance of the chain. In this dusty region riding car, the more maintenance is necessary.
Page 19
Throttle limited & parking function Note: The battery electrolyte checks at least once a month. Warning: Please use parking button when you are parking,see picture. ● use batteries to be recharged in 30 minutes and cooled to 1、Fasten front brake room temperature to ensure the proper use of batteries.
Page 20
With the correct installation of the new ampere fuse. Connect the switch and watch the work of electrical installations. Fusing immediately if the fuse again, please COOLSTER dealer or repair shop contact. Warning: ● Do not use the recommended ampere rating higher than the fuse.
CLEANING 1, in order to keep the car clean and protect the surface appearance of the painting, electroplating, should regularly or irregularly its cleansing. When cleaning, use of external surface water irrigation, rush soil. Use a soft cloth or sponge dip cleaning liquid bubble gently cleans the outer surface, to avoid residual gravel surface and paint scratches electroplating layer.
Page 23
STORAGE 7) to inflatable tires, tire pressure up to the required standard air pressure. After stopping the car will be good, If the park does not need to use a long time, in order to with shelves or pieces of wood and other wheels will be maintain a good state of the car, you please address the boosted so that the wheel does not contact with the ground.
ATV-3050C INSTALL PROCESS AFTER UNPACKING(1) ATV-3050C INSTALL PROCESS AFTER UNPACKING(2) Disassembled packaging belt Take out carton Install rear rack Install handle bar Disassembled metal frame Disassembled metal frame Install front wheel Remove rear axle fasten Pick parts out Install front protector...
Page 25
ATV-3050C INSTALL PROCESS AFTER UNPACKING(3) ATV-3050C INSTALL PROCESS AFTER PACKAGING(4) Correspondence tables fastening torque Fightening Standard torque torque Screw size N•M N•M 4.5-6.0 Fill liquid of battery Install seal of battery 8-12 16-26 37-79 73-115 Install battery & link wire...
EMISSIONS WARRANTY PARTS LIST Emission Warranty Statement. Fuel metering System Ignition System Exhaust System Emission Control System Carburetor Spark Plug Exhaut Manifold Air Cleaner Housing U.S.A. EPA Emissions Limited Warranty Air Cleaner Housing Cov. This All Terrain Vehicle (ATV) and Off Highway Motorcycle (OFMC) emissions limited warranty is in addition to the Maxtrade standard limited warranty for All Model Yera: 2013 or Later Models Terrain Vehicles.
Page 27
ATV-3050C Main specs (1) ATV-3050C Main specs (2) 3.16 Carburator no........PZ20 1,The main specs of size 3.17 Carburator type........ Plunger 1.1 Model dimensions......1250×900×940(L•W•H) 3.18 Spak plug no........D7TC 1.2 Wheel base 3.19 Spark plug space....... 0.6-0.7 a)wheel base front........
Page 28
Spark Arrestor Screen (Maintenance) Required maintenance and cleanout: 1. After every 100 hours of operation the muffler should be cleaned by removing the clean out bolt by using a 6.0mm Allen wrench. 2. After every 60 hours of operation the Spark Arrester has to be cleaned by loosening the retaining nut using a 6.0mm Allen wrench.
Page 29
Terms/ Conditions at any The following items are not covered: time without prior notice ,improvements to products may result in unannounced small Blades tires, tines rims , body panels ,fuses, forks ,shocks, gaskets, light bulbs, seats ,CV Boots, changes to specifications and external appearance, We strive to list and advertise all text and...
Need help?
Do you have a question about the ATV-3050C and is the answer not in the manual?
Questions and answers
What size oil filter does this one use
The size of the oil filter for the Coolster ATV-3050C is not specified in the provided context.
This answer is automatically generated