Pioneer SD-533HD5 Service Manual page 205

- SPLIT/SEARCH screen buttons
FREEZE: When this button is pressed with the regular
screen, the screen will change to the SPLIT
screen and the picture at the time the button
was pressed will become the sub-picture,
displayed as a frozen image.
SPLIT: Press to turn the SPLIT screen function on
and off.
SEARCH: Press to select the SEARCH screen mode.
SWAP: Press to switch the main picture and sub
picture when in SPLIT or 3-SEARCH screen
mode.
SELECT: Selects the screen for switching the channel
or input source.*
SUB CH +, –: Used to switch the channel for the sub-
picture of the SPLIT screen.
= SLEEP timer button
Each time this button is pressed, the display will change
as follows.
The display varies according to the remaining time.
Example:
If the remaining time is 100 minutes
100 min. 90 min.
120 min.
If the remaining time is 45 minutes
45 min. 30 min.
60 min.
90 min.
~ CH ENTER button
Fix the selected channel with the direct channel selection
buttons.
! CH RETURN (channel return) button
Press to switch between the current channel and the
channel you were watching immediately before.
@ VOL (volume) +, – buttons
Press plus (+) button to increase the volume, press minus
(–) button to decrease it.
Volume level will appear on the screen as numbers and a
bar graph. The maximum volume level is "63".
The display will disappear from the screen after 2 seconds.
# MENU button
Press to turn on the menu screen for use in function
selection.
Press again to return to normal TV screen.
1
60 min.
30 min.
OFF
OFF
120 min.
SD-533HD5, SD-643HD5
*1 With the 9-SEARCH screen, the search picture's input
source and channel cannot be switched.
NOTE:
If the remote control unit is left in total darkness for a long period of time, it
will not emit light, but will not be damaged. In this case, place it in a bright
place for a little while before using it.
205