Important Safety Requirements; Provision For Ventilation; Moving Your Appliance; For Your Safety - Zanussi ZCM 7701 Instruction Booklet

INSTALLATION INSTRUCTIONS
IMPORTANT – SAFETY REQUIREMENTS
This appliance must be installed in accordance with the Gas Safety (Installation and Use) Regulations Current
Editions and the I.E.E. Wiring Regulations. Detailed recommendations are contained in the following British
Standard Codes of Practice – BS.6172, BS.5440: Part 2 and B.S.6891. All British Standards must be 'Current
Editions'.

PROVISION FOR VENTILATION

This appliance is not connected to a combustion products evacuation device. It shall be installed and connected
in accordance with the current installation regulations. Particular attention shall be given to the relevant
requirements regarding ventilation.
The room containing the appliance should have an air supply in accordance with BS.5440: Part 2 Current Edition.
All rooms require an openable window or equivalent and some rooms will require a permanent vent as well. For
3 2 3 3
room volumes up to 5m an air vent of 100cm is required: for room volumes between 5m and 10m an air vent of
2
50cm is required. If the room has a door that opens directly to the outside, no air vent is required. For room
3
volumes that exceed 11m no air vent is required. If there are other fuel burning appliances in the same room,
BS.5440: Part 2 Current Edition should be consulted to determine the requisite air vent requirements.
Prolonged intensive use of the appliance may call for additional ventilation, for example opening a window, or
more effective ventilation, for example increasing the level of mechanical ventilation where present.

MOVING YOUR APPLIANCE

You may damage some soft or badly fitted floor coverings when you move the appliance. The floor covering
under the appliance should be securely fixed so it does not ruck up when you move the appliance across it.
Alternatively you could remove the floor covering.
To move the appliance open the grill door. Raise the appliance off its front feet by lifting it from inside the oven.
Pull the appliance forward. When you replace the appliance push it back to the stop and make sure there is the
same gap at each rear corner.

FOR YOUR SAFETY

Do not try to disconnect the appliance from the gas supply if the supply pipe does not have a bayonet connection,
as described in the installation instructions. If this is the case contact the person who installed the appliance.
30