Troubleshooting - Water Tech Pool Blaster Pulse Manual

TROUBLE SHOOTING
Problem
Cleaner does not capture the debris
Debris escapes from the filter
Debris goes inside the filter cone
Handle / pole connector cannot be
secured in assembly
Cleaner cannot be recharged
Vacuum head does
smoothly
Possible Cause
Battery is running out
Impeller is jammed
Impeller is broken
Filter is full
Suction nozzle flap is broken
Filter sock is damaged
Filter sock is not in place
Outlet valve comes off
Side pin broken
Battery is dead
External adaptor is out of order
not move Wheels jammed or damaged or
excessive build-up of dirt in
wheel or adapter cavities
Water Tech Corp.
East Brunswick, NJ 08816 - USA
Tel: 1-800-298-8800
Fax:-1800-488-0700
10 Alvin Ct.
Remedy
Charge the battery again. Normally
cleaner can operate 30-40 minutes
after fully charged.
Power off the cleaner and visually
check the gap in middle of the
cleaner to see if the impeller is
jammed by larger debris. If possible,
use small tool to remove it with
intensive care & caution. If
necessary, contact your dealer for
instruction.
WARNING! Make sure cleaner is
powered off when servicing the
cleaner.
Contact your dealer for impeller
replacement.
Clean the filter and filter sock.
Suction nozzle flap works like a door
to prevent the debris from escaping
from the filter. Contact dealer for
replacement part and instruction.
Replace a new filter sock.
Make sure the filter sock is placed
and secured on the filter cone before
operation.
Without outlet valve, cleaner might
capture from this hole. Contact
dealer for valve replacement.
Replace a new handle / pole
connector.
Contact dealer for battery
replacement.
WARNING! DO NOT open the
cleaner and replace the battery by
yourself. This will result in severe or
fatal injury and void the warranty.
Contact dealer for proper
transformer.
WARNING! Using wrong external
adaptor will result in damaging the
cleaner / battery and void the
warranty.
Rotate the wheels by hand to
confirm they are not jammed. Look
for damage or excessive wear.
Clean out the wheel and adapter
cavity.