Do you have a question about the W600 Series and is the answer not in the manual?
Questions and answers
Tasos
June 24, 2025
Cuting short the needles threads and when you start again the threads are too short and leave the needles
1 comments:
Mr. Anderson
August 23, 2025
If the needle threads are too short when using the Pegasus W600 Series, trim the knots off neatly before passing the thread through the eye of the needle and rethread the machine correctly by referring to the threading diagram.
Need help?
Do you have a question about the W600 Series and is the answer not in the manual?
Questions and answers
Cuting short the needles threads and when you start again the threads are too short and leave the needles
If the needle threads are too short when using the Pegasus W600 Series, trim the knots off neatly before passing the thread through the eye of the needle and rethread the machine correctly by referring to the threading diagram.
This answer is automatically generated