Table of Contents
Advertisement
Troubleshooting
If there is a problem with the binoculars, first refer to the table below to see if
you can resolve it. If the problem cannot be resolved, contact your dealer or
nearest Canon Service Center.
Problem
The image is not
clear.
The Image Stabilizer
does not operate.
Probable Cause
The lens is dirty.
The diopter has not been
properly set.
The width of the binoculars
does not suit the width
between your eyes.
The binoculars are not
properly focused.
There are no batteries
loaded.
When the Image Stabilizer
button is pressed, the lamp
does not light.
Corrective Measures
Use a blower brush to
remove dust, etc., from the
lens surface. Then use a
soft, dry cloth to wipe the
lens gently.
Adjust the diopter.
(See step 3 on page 9)
Adjust the width of the
binoculars.
(See step 2 on page 9)
Focus the binoculars.
(See step 4 on page 9)
Load batteries having
enough power.
(See page 7 "Loading the
Batteries")
If the lamp does not light,
it means the batteries are
exhausted. Replace the
batteries with new ones.
(See page 7 "Loading the
Batteries")
ENG-12
Advertisement
Table of Contents
