Siemens PXC00-PE96.A Installation Instructions

Andover Infinet Driver for PXC Modular
These installation instructions only cover the
connection of the Andover Infinet Driver to the
Andover Infinet network. For hardware installation of
the PXC Modular Controller, see PXC Modular
Series Installation and Quick Start (553-638).
Product Description
The Andover Infinet Driver enables communication
®
between the APOGEE
Andover Infinet/Infinet II devices.This is done by
removing the Andover CX Network Controller and
replacing it with the Andover Infinet Driver, allowing
the Driver to control the Andover Infinet network.
Product Numbers
PXC00-PE96.A PXC Modular RS-485 or
Ethernet ALN, 96 FLN nodes
PXC100-PE96.A PXC Modular RS-485 or
Ethernet ALN, TX-I/O
Support, 96 FLN nodes
PXX-485.3 Expansion Module, three RS-
485 FLN connections
LSM-INT-ANDVRINET PXC Modular Andover Driver
License
Warning/Caution Notations
WARNING:
CAUTION:
Item Number 565-719, Rev. BA
Automation System and the
Personal injury/loss of life may
occur if you do not follow the
procedures as specified.
Equipment damage, or loss of
data may occur if you do not
follow the procedures as
specified.
Installation Instructions
Required Tools

Flat-blade screwdriver (1/8-inch blade
width).

Wire strippers.
CAUTION:
Always wear an electro-static discharge wrist
strap and discharge accumulated static before
touching field panel components.
Expected Installation Time
30 minutes
Prerequisites

Driver hardware is installed according to its
respective installation instructions.

FLN Expansion Module is installed
according to its respective installation
instructions.
Depending on the type of installation, other
prerequisites may have to be completed.
Document No. 565-719
July 22, 2016
Page 1 of 2