Britax CLICK & GO Quick Start Manual

TO RELEASE THE INFANT CARRIER FROM
STROLLER
5a
5
a. Squeeze both carry handle release latches to release the
handle and rotate upwards.
b. Rotate the handle upwards towards the "carry position" to
unlock the carrier from the stroller.
c. Once handle is locked in the "carry position" lift and remove
the Infant Carrier away from the stroller frame.
IMPORTANT: These Instructions are for installing and
removing the Infant Carrier on the stroller only. Refer to the
Infant Carrier Instruction book regarding placing and
securing your baby in the Infant Carrier.
HOW TO REMOVE THE AGILE CLICK & GO
RECEIVER
6 To remove the Agile Click & Go Recievers, press the grey button
on the inside of the receiver and pull the receiver up out of the
stroller hinge.
www.britax.com.au
Customer Service: 1300 303 330
5c
Art No. 4001571
AGILE CLICK & GO RECEIVER
Receiver for an Agile Stroller to accommodate
a Britax Safe-n-Sound Unity Infant Carrier*
where Britax Stroller Click & Go Adapter* is fitted.
L
*Receivers only fit Series No. 40/A/2010 Unity Infant Carrier models.
Britax Stroller Click & Go Adaptor sold separately.
AGILE CLICK & GO RECEIVERS ARE MARKED
'L' (LEFT) AND 'R' (RIGHT) FOR CORRECT FITTING
HOW TO FIT
1
1 Agile Receivers fit onto both sides of the Agile Stroller. Take one
Agile Receiver at a time and insert into the stroller hinge as shown.
Push on the receiver until you hear a 'click' which indicates the
receiver has locked in. Pull up on each receiver to check they have
fully engaged.
R R