Britax BOB Gear SNACK TRAY Manual

The BOB Snack Tray provides a place for your child to keep sippy cups and snacks at their fingertips.
FAILURE TO FOLLOW THESE WARNINGS AND INSTALLATION INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY OR DEATH.
• Do not place children on top of Snack Tray or allow them to sit, step on, or ride on Snack Tray.
• Do not place car seat on top of Snack Tray. Snack Tray is not intended to be used as an infant car seat adapter.
• Do not exceed 3 lbs/1.3 kg on Snack Tray. Exceeding can create an unstable condition and cause your stroller to
tip over, leading to injury.
• Do not jog or use off-road with foods or liquids directly in Snack Tray. Use spill resistant cup for children, and
watch for bumps or uneven surfaces while strolling, as contents may spill off of tray.
• Avoid injury from burns. Do not use with hot foods or liquids.
• To avoid finger entrapment or injury, do not remove or rotate the tray with children or bystanders near the release
buttons or locking plungers.
• Do not allow children to remove or rotate the tray.
• Do not leave Snack Tray in the rotated or open position at any time.
• Discontinue use if Snack Tray becomes damaged or if any parts are missing.
• Do not install, remove, or rotate Snack Tray unless the stroller is stopped, the parking brake is engaged, and
Snack Tray is empty.
• Pull on the front of the Snack Tray to ensure it is properly secured in accessory adapter prior to use.
• Always use harness to secure child.
IMPORTANT NOTES
• Stroller may be folded with Snack Tray attached. However, a more compact fold can be achieved if Snack Tray is
removed prior to folding stroller. See stroller user guide for folding instructions.

COMPATIBILITY

This Snack Tray is designed for use with BOB single strollers manufactured 2011 or later.
BOB Weather and Sun Shield products are compatible with the Snack Tray. Install Shield on stroller after Snack Tray is
installed. Refer to Weather or Sun Shield user guide for proper usage and set up to ensure proper air flow.
SNACK TRAY
Locking
End Caps
INSTALL SNACK TRAY
1. Prepare stroller
Set parking brake, rotate canopy towards
handlebar (see stroller user guide if necessary).
NOTE: For strollers manufactured prior to
September 2015, slide down the covers at the
front of the stroller accessory adapters down to
expose the receiver sockets (Fig. 1).
2. Align locking end caps
Align and insert each locking end cap on Snack
Tray into the respective accessory adapter
receiver socket (Fig. 2).
Tray
Locking
Plungers
®
BOB Gear by Britax (888) 427-4829 www.bobgear.com
4140 Pleasant Road, Fort Mill, South Carolina 29708
STROLLER ACCESSORY ADAPTER
Anchor Nut
Receiver
Socket
Socket
Cover
Release
Button
Before September 2015
Receiver
socket
covers
1
SNACK TRAY
Single
Anchor Nut
Receiver
Socket
Release
Button
After September 2015
2
P05331500_A:12.17
1