Clarke BEXT 100H Operation?And Safety

Safety Practices:
Machine can cause an
explosion when operated
near flammable material
and vapors. Do not use
this machine with or near
fuels, grain dust, solvents,
thinners or other
flammable materials.
Always use a 3- wire
electrical system
connected to the electrical
ground.
Keep hands, feet, and
loose clothing away from
all moving parts on the
machine.
Remove the electrical plug
from the electrical outlet
before doing any repairs or
maintenance to this
machine.
Never leave the machine
unattended while it is
connected to a power
source.
It is recommended that
you use liquid cleaning
chemicals. Powder can
damage the machine.
Do not use water that is
hotter than 120°F (40° C).
www.clarkeus.com/rental
More on reverse....
BEXT 100H Extractor
Operation and Safety
Application: Easily extract large or confined carpeted areas such as
stairs or tight office spaces. Use optional hand tool when cleaning
partition, fabrics and upholstery.
Set-up and operation
Follow the steps below to successfully use extractor:
Step
To set-up machine:
a.) Connect vacuum hose to the
hose connector on the
extractor (1) and to the end of
the vacuum tube on the floor
tool (2).
b.) Connect the solution hose (3)
to the extractor and the floor
tool (4).
c.) Put clean hot water into the
solution tank (5).
d.) Add a cleaning chemical to the
hot water (for amount see
container).
e.) Plug in cord #1 (identified by
red "H" on the end).
f.) Turn pump on (6) and set the
switch to "Upholstery" setting.
Run till pump is fully primed
and then turn off pump.
1 g.) Remove the priming hose and
attach the cleaning hose & tool.
h.) Turn on the pump and spray
through the cleaning tool for a
few seconds to fill line with
solution.
i.) Plug in cord #2. The "locator
light" (7) will light up when the
cords are plugged into
separate circuits.
j.) Turn "heat" switch on and wait
2 minutes to reach operating
temperature.
k.) Begin cleaning (see steps 2
and 3).
NOTE: The "mode" light will turn
on when the heat exchanger is
actively heating.
NOTE: If the "locator" light does not
light when cord #2 is plugged in, try
another outlet until it does come on.
Action