Table of Contents
Advertisement
Setup
Setup
Accessory Removal
Remove any mid-mount accessory that is currently on
the machine; refer to the Z-Plug Operator's manual
and the installed accessory Operator's manual for
instructions.
Install Accessory
1.
Remove the cotter pin, washer, and hitch pin
from the lower swivel ball on the lift mechanism.
2.
Remove the lynch pin from the pull pin at the
front of the machine.
3.
Remove the lynch pins from the lift pins on the
lift mechanism (both sides).
4.
Drive the Z-Plug machine to the rear of the
accessory. Position the rear wheel to the middle
of the accessory. Slowly start turning the machine
over the accessory (make sure that you line up the
ball swivel in the neck of the accessory and the
pull pin beneath the nose of the traction unit to
make it easy for mounting).
1. Turning towards accessory
5.
Shut off the engine, wait for all moving parts to
stop, and remove key.
6.
Slide the swivel ball at the front of the accessory
over the pull pin at the front of the machine.
Figure 2
7.
Install the lynch pin to retain the swivel ball to
the pull pin.
1. Hitch pin
2. Swivel ball
3. Washer
8.
Start the machine and lower the lift mechanism
using the hydraulic cylinder until the swivel balls
at the end of the accessory chains can be installed
over the lift pins on the lift mechanism.
9.
Install lynch pins to retain the swivel balls to the
hitch pins.
10.
Raise the lift mechanism center linkage using the
hydraulic cylinder until the lower swivel ball aligns
with the holes in the accessory.
Note: Small adjustments may need to be made to
the lift mechanism center linkage when attaching
the accessory.
11.
Shut off the engine, wait for all moving parts to
stop, and remove key .
g293242
12.
Install the hitch pin, washer, and cotter pin to
retain the accessory to the center linkage lower
swivel ball.
8
Figure 3
4. Cotter pin
5. Lynch pin
g299471
Advertisement
Table of Contents
