Subscribe to Our Youtube Channel
Related Manuals for Exmark Z-Plug 142-1850
Summary of Contents for Exmark Z-Plug 142-1850
- Page 1 142-1850 SPIKER HEAD 40 INCH For Serial Nos. 406,294,345 and Higher Part No. 4504-503 Rev. A...
-
Page 2: Introduction
Providing this information will help assure that you get the correct parts, informed about any updates or product reviews. Model Number: ____________________________________ Serial Number: ____________________________________ ©2019 Exmark Mfg. Co., Inc. Contact us at www.Exmark.com. 2101 Ashland Ave Printed in the USA Beatrice, NE 68310 All Rights Reserved... -
Page 3: Table Of Contents
Contents Introduction ............2 To the Owner..........2 Safety ..............4 Safety Alert Symbol ......... 4 Safe Operating Practices ........4 Safety and Instructional Decals ....... 6 Specifications ............7 Systems ............7 Dimensions............. 7 Setup ..............8 Accessory Removal ......... 8 Install Accessory .......... -
Page 4: Safety
Safety Safety manuals it is the owner’s responsibility to explain this material to them; other languages may be available on our website. Safety Alert Symbol • Become familiar with the safe operation of the This Safety Alert Symbol (Figure 1) is used both in equipment, operator controls, and safety signs. - Page 5 Safety Operation WARNING Hands, feet, hair, clothing, or accessories can become entangled in rotating parts. Contact with the rotating parts can cause traumatic amputation or severe lacerations. • Do Not operate the machine without guards, shields, and safety devices in place and working properly.
-
Page 6: Safety And Instructional Decals
Safety Safety and Instructional Decals decal133-8061 133-8061... -
Page 7: Specifications
Specifications Specifications Systems Spiker 18 Rows of spikes Dimensions Overall Width: 46 inches (117 cm) Overall Length: 31 inches (79 cm) Overall Height: 22 inches (56 cm) Weight: 305 lb (138 kg) -
Page 8: Setup
Setup Setup Install the lynch pin to retain the swivel ball to the pull pin. Accessory Removal Remove any mid-mount accessory that is currently on the machine; refer to the Z-Plug Operator’s manual and the installed accessory Operator’s manual for instructions. -
Page 9: Operation
Operation Operation Lower front neck of the accessory and block up the accessory so it can be stored safely and will make future reinstallation easier. Dethatching Operations Position yourself back on the traction unit. Drive away from the accessory head (reference Figure 5) Operation by turning the front of the traction unit in either direction. -
Page 10: Maintenance
Maintenance Maintenance Periodic Maintenance Ensure that all collars are tight and adjusted properly. Always shut off the engine, and remove the key. Wait for all movement to stop and allow the machine to Lubricate each bearing once a year. cool before adjusting, cleaning, storing, or repairing it. -
Page 11: Information
While the exposure from Exmark products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Exmark has elected to provide the Prop 65 warnings. Moreover, if Exmark does not provide these warnings, it could be sued by the State of California or by... - Page 12 Pack) or Fill in Below Engine Model No. and Spec. No. Model No. Engine Serial No. (E/No) Serial No. ©2019 Exmark Mfg. Co., Inc. Part No. 4504-503 Rev. A 2101 Ashland Ave (402) 223-6375 Beatrice, NE 68310 Fax (402) 223-5489...
Need help?
Do you have a question about the Z-Plug 142-1850 and is the answer not in the manual?
Questions and answers