Installation Instructions; Weather Protection; Power Connection - Oasis P Series Installation And Operation Manual

DIMENSIONS

INSTALLATION INSTRUCTIONS

Location
The pump should be located as close to the water as practicable and mounted on a firm base in
a well-drained position, high enough to prevent any flooding. It is the installer's/owners
responsibility to locate the pump so that it can be accessed for service and maintenance. The
rear fan shroud should be installed at a minimum distance of 100 mm away from any walls or
obstructions. This is to allow adequate air flow from the fan to cool the motor. Overheating due
to a lack of cooling voids warranty.

WEATHER PROTECTION

It is recommended that the pump be protected from the weather.
Enclosures should be ventilated to allow a free flow of air for the fan cooled motor.

POWER CONNECTION

OASIS pool and spa pumps are suitable for connection to a nominal 240-volt 50Hz power supply.
The motor is equipped with a flex and 3-pin plug. If a power outlet is not available within 2 meters of
the pump, a 3-pin power point in a safe, dry place may need to be provided by an electrician.
Note:
•
Pumps must be either
o Supplied by an isolating transformer, or
Supplied through a residual current device (RCD) with a rated residual operating current
o
not exceeding
•
Extension cords are unsafe around pools and must be avoided.
•
If the supply cord of this product is damaged the dealer or manufacturer must replace it,
with genuine OASIS pool and spa pump spares.
•
Water temperature is not to exceed 45 degrees
P SERIES HIGH PERFORMANCE - P270 | P330 | P380 | P490 POOL & SPA PUMP
INSTALLATION AND OPERATION MANUAL
670
V390
@
700
30mA.
info@oasisaquatics.com.au
oasisaquatics.com.au
5