Oasis P Series Installation And Operation Manual page 10

PLEASE NOTE
• If the pump is hard wired, a qualified electrician should remove the wiring.
• On some models the pump is fitted with an internal check valve to reduce reverse flow of
water through the pump.
• Barrel unions need to be hand tightened. No sealant, glues or silicones are required.
• When making any enquiries about your OASIS pool and spa pump be certain to quote the
model number from the nameplate located on motor.
• Never run pump dry. Running the pump with no water may damage the mechanical seals,
causing leakage and flooding. Dry running damage and associated damage is not covered
under warranty.
• Failure to undertake regular maintenance may cause damage not covered by warranty.
• The pump is not intended for use by young children or infirm persons without supervision.
Ensure that young children are supervised at all times to ensure that they do not play with
the pump.
COMMERCIAL INSTALLATIONS
On Commercial Installations, such as health clubs, swim schools, motels/hotels and hydrotherapy,
parts and in field labour warranty (within capital city metropolitan areas or 20km radius of
authorised service agents) is 6 months from the date of purchase.
Oasis assumes no liability for consequential damages of any kind.
PLEASE NOTE
This literature is not a complete guide to product usage. Further information is available from your
OASIS dealer, OASIS Customer Service Centre and from the relevant product Installation and
Operating Instructions.
• This data sheet must be read in conjunction with the relevant product Installation and
Operating Instructions and all applicable statutory requirements. Product specifications
may change without notice.
• Warranties vary in different States and/or Territories.
P SERIES HIGH PERFORMANCE - P270 | P330 | P380 | P490 POOL & SPA PUMP
INSTALLATION AND OPERATION MANUAL
info@oasisaquatics.com.au
oasisaquatics.com.au
10