Remote Control Operating Mode; Alteia Support - Ericsson RX8 Series Manual

Supported Alteia Protocol Commands and Messages
4. Status returned if:
1 and 2 are passed and the message is a status request. Status requests return a
message containing the required data. Refer to Section 4 for supported status
messages.
There are no returns other than those for status and those listed above. Commands
with and without checksums included at the end are accepted by the IRD.
3.2

Remote control operating mode

The RX8200 Receiver is working always in Remote Control Mode if the Remote Data
Card is present. In this case the Remote Control functionality will be always available.
That's a difference compared to the RX1290 receivers, where the Remote Control
Operating Mode was switchable.
3.3

Alteia Support

The supported Alteia protocol commands are a subset of the previous remote control
protocol. The RX8200 implementation of this protocol provides all Alteia commands
within the limits of this unit's specification. Any required set-up that is not supported by
the remote control must be carried out using the other user interfaces.
The Alteia protocol main commands are listed below.
Refer to Section 4 for the full list of supported commands and sub-commands:
• Tuner commands (TUN)
• Demodulator commands (DEM)
• Decoder commands (DEC)
• DVB-T commands (DTV)
• IP input commands (IPI)
• G703 input commands (703)
• Terrestrial input commands (DTV)
• 8VSB tuner/demodulator commands (ATS)
• Service Enquiry commands (ENQ)
• Service Selection commands (SER)
• System Index Bypass Service Selection commands (SIB)
• Operational Status commands (OPR)
• CA commands (CAS)
• Video commands (VID)
• 4:2:2 Mode commands (422)
• Subtitle/VBI commands (SVB)
• Audio 1 commands (AUD)
• Audio 2 commands (AU2)
14 (59)
Document No. ST.TS.EXXXXX.1 2010-03-04